Filter
Top Products
6
Keeping your shaver in top shape
Automated cleaning
The Braun Clean&Charge (only with models 7520, 7516)
automatically takes care of all cleaning and lubrication
needs of your shaver. Please refer to separate use
instructions.
Manual cleaning
For easy cleaning after each shave, switch the shaver
off. Press the release buttons to lift the shaver foil
(do not remove the foil completely).
Switch on the shaver
for approx. 5-10 seconds so that the shaved stubbles can
fall out.
For a thorough cleaning (weekly), remove the shaving
foil and tap it out on a flat surface. Using the brush,
clean the cutter block and the inner area of the pivoting
head. About every four weeks, clean the cutter block
with Braun cleaning agents.
If your skin is very dry and you notice a reduced operation
time of the shaver, apply a drop of light machine oil onto
the shaver foil.
Replacing the shaving parts
To maintain 100% shaving performance, replace your
foil and cutter block at least every 18 months or when
worn. Change both parts at the same time for a closer
shave with less skin irritation.
(Shaver foil and cutter block: part no. 7000)
Preserving the cell unit
•
In order to maintain the optimum capacity of the
rechargeable battery, the shaver has to be fully dis-
charged (by shaving) every 6 months approximately.
Then recharge the shaver to full capacity again.
This reconditions the rechargeable battery.
•
Do not expose the shaver to temperatures of more than
50°C for longer periods of time.
oil
10
10
7000
7000
Syncro
5493325_Syncro_7520_S_S 4-54 Seite 6 Freitag, 31. März 2006 9:38 09