Filter
Top Products
26
« » shaver is clean
« » short economical cleaning required
« » normal level of cleaning required
« » high intensive cleaning required
If the station selects one of the required cleaning
programs, it will not start unless you press the
start button 4. For best shaving results, we
recommend cleaning after each shave.
Each cleaning program consists of several
cycles, where cleaning fl uid is fl ushed through
the shaver head. Depending on the program
selected, the cleaning time takes 3 to 15 minutes
and drying takes about 4 hours. During this time
the respective indicator blinks.
The cleaning program should not be interrupted.
Whilst the shaver is drying, the shaving head
may be wet.
When the program is fi nished, the blue «
»
indicator will light up. Your shaver is now clean
and ready for use.
Stand-by mode
10 minutes after completing the charging or
cleaning session, the Clean&Renew station
switches to the stand-by mode: The indicators
of the Clean&Renew station turn off.
Shaver display
The shaver display z shows the charge status
of the battery. During charging or when using the
shaver, the respective green charge status will
blink. When the battery is fully charged the green
charge status will light up continously, provided
the shaver is switched on or connected to an
electrical outlet.
Stand-by mode
(Shaver is switched off but connected to the
mains)
Some minutes after completing the charging, the
shaver switches to the stand-by-mode:
The display turns off.
Low charge indicator:
The red « » charge indicator blinks to
indicate that the charge has dropped below
20%, provided the shaver is switched on.
The remaining battery capacity is suffi cient
for 2 to 3 shaves.
99503924_750cc-4_Japan.indd 2699503924_750cc-4_Japan.indd 26 14.04.2010 10:19:43 Uhr14.04.2010 10:19:43 Uhr