Filter
Top Products
8
Keeping your shaver in top shape
Cleaning
For easy cleaning after each shave, switch the shaver
off. Press the release buttons to lift the shaver foil
(do not remove the foil completely).
Switch on the shaver
for approx. 5-10 seconds so that the shaved stubbles can
fall out.
For a thorough cleaning (weekly), remove the shaving
foil and tap it out on a flat surface. Using the brush,
clean the cutter block and the inner area of the pivoting
head.
If your skin is very dry and you notice a reduced operation
time of the shaver, apply a drop of light machine oil onto
the shaver foil.
Do not rinse the shaver in or under water.
Replacing the shaving parts
To maintain 100% shaving performance, replace your foil
and cutter block every 18 months or when worn. Change
both parts at the same time for a closer shave with less skin
irritation.
Available at your dealer or Braun Service Centers:
(Shaver foil and cutter block: part no. 7000)
Preserving the cell unit
In order to maintain the optimum capacity of the
rechargeable batteries, the shaver has to be fully
discharged (through normal use) every 6 months
approximately. Then recharge the
shaver to full capacity.
Do not expose the shaver to temperatures of more than
122°F / 50°C for longer periods of time.
oil
10
10
7000
7000
Syncro
5494308_S 4-26 Seite 8 Mittwoch, 21. September 2005 3:28 15