Braun 603B Mobility Aid User Manual


 
Page 11
Lift Operating Instructions
UP
STOW DOOR
CLOSE
DOWN
THE BRAUN
CORPORATION
86478
UP
LIFT
DOWN
LIFT
LIFT
81812
DOOR
CLOSE
STOW
Hand-held Switchbox
(Standard Equipment)
Optional Remote
Control Transmitter
Lift Control Switches:
The UVL
®
logic control system provides fully auto-
matic operation of all lift functions as well as op-
tional automatic door operators (if so equipped).
Lift functions can be performed from any position
the platform happens to be in at the time the switch
button is pushed.
There are two types of hand controls available for
the UVL - the standard hand-held control switchbox,
or the optional remote control. Both types of
controls are equipped with four push-button
switches. The functions activated by both types of
controls are the same. The switch functions are
labeled. The function of each switch is described
below.
Remote Control Note: The effective range of the
remote control is 20 feet. A range further than 20
feet does not allow an attendant to observe and
assist the lift passenger.
Control Switch Functions:
UP: From the stowed position, the LIFT UP function
deploys (extends) the platform fully. The platform
then raises to floor level height and moves inward to
the vehicle floor level position (if applicable). Note:
When the lift is in the stowed position, power doors
automatically open when the UP switch is pressed
(if so equipped).
From ground level, the LIFT UP function will first
automatically raise (rotate) the outboard roll stop to
the upright (vertical) position. Note: The lift will not
raise if the roll stop is not in the UP position (built-in
safety feature). The platform then raises to floor
level height and moves inward to the vehicle floor
level position. Note: UVL600 and UVL600X lift
models move inward to floor level position with an
“arcing” motion. UVL850 Series lift models do not.
DOWN: The LIFT DOWN function lowers the
platform to ground level (regardless of the position
of the platform) and then unfolds the outboard roll
stop to the ramp (horizontal) position. From the
stowed position, the lift will extend and then lower.
Note: When the lift is in the stowed position, power
doors automatically open when the DOWN switch is
pressed (if so equipped).
STOW: The STOW LIFT function raises or lowers
the platform to stow level and then moves the
platform inward (retracts) to the stow position.
W
A
RNING
Fold handrails down
before stowing lift.
Failure to do so may
result in serious
bodily injury and/or
property damage.
Note: The lift will not
stow with weight on the
platform (built-in safety
feature).
Fold handrails down
before stowing lift.
Failure to do so may
result in serious
bodily injury and/or
property damage.
DOOR CLOSE: When the vehicle is equipped with
automatic door openers (optional), the DOOR
CLOSE switch closes the doors. This function
operates only when the platform is stowed or fully
extended and below stow level.
Note: If any of these functions do not occur as
described, discontinue lift use immediately and
contact your sales representative or call The Braun
Corporation at 1-800-THE LIFT. One of our national
service representatives will direct you to an autho-
rized service repairman who will inspect your lift.
In event of power or equipment failure, refer to
Manual Operating Instructions to manually operate
(stow) the lift, then contact your sales representative
for further instructions.