Filter
Top Products
12
has to be fully discharged (by shaving) every
6 months approximately. Then recharge the
shaver to full capacity.
Environmental notice
This product contains rechargeable
batteries. In the interest of protecting
the environment, please do not
dispose of the product in the house-
hold waste at the end of its useful life.
Disposal can take place at a Braun Service
Centre or at appropriate collection sites
provided in your country.
C Clean&Renew™
Braun Clean&Renew™ has been developed
for cleaning, charging and storing your shaver.
Clean your shaver daily in the Clean&Renew™.
During the automated cleaning process, the
shaver is switched on and off at intervals
to obtain best cleaning results. Since the
specially formulated cleaning fluid contains a
small amount of oil, the cleaning procedure
also fulfils the lubrication needs of the shaver.
Important
Only use the power supply cord set
supplied with the shaver.
In order to avoid any leakage of the
cleaning fluid, place the appliance on a flat,
stable surface. Do not tip, move suddenly
or transport in any way if a cleaning
cartridge is installed.
Do not place the appliance in a mirror
cabinet, nor store it over radiators, nor
place it on polished or lacquered surfaces.
Do not expose to direct sunlight.
The appliance contains highly flammable
liquid. Keep it away from sources of
ignition. No smoking.
Keep out of reach of children. Do not refill
cartridge. Use only original Braun refill
cartridge.
•
•
•
•
•
Description
1 Start/release button
2 Contact bow
3 Lift button for cartridge exchange
4 Level indicator
5 Cleaning cartridge
Before using Clean&Renew™
Installing the cartridge
Press the lift button (3) to open the housing.
Hold the cartridge down on a flat, stable
surface (e.g. table). Carefully remove the lid
from the cartridge. Slide the cartridge into
the base as far as it will go.
Slowly close the housing by pushing it
down until it locks.
Replacing the cartridge
After having pressed the lift button to open
the housing, wait for a few seconds before
removing the used cartridge.
Before discarding the used cartridge, make
sure to close the openings using the lid of the
new cartridge, since the used cartridge will
contain contaminated cleaning solution.
The used cartridge can be disposed in the
household waste.
Operating your
Clean&Renew™
Connect your Clean&Renew™ with the
cord set to the mains electricity supply.
The special socket at the back is adjust-
able to save space. After each shave,
switch the shaver off and put it into the
Clean&Renew™, upside down and with
the front showing.
Push the start/release button (1) to lock
and connect the shaver. The cleaning
process will start. The yellow light on the
shaver will flash during the complete
process (approx. 2 minutes cleaning,
min. 4 hours drying).
Do not interrupt the cleaning process, as it
leaves the shaver wet and not fit for use. If
•
•
•
•
•
•
99470524_395cc_S6-64.indd 1299470524_395cc_S6-64.indd 12 02.03.2010 8:22:34 Uhr02.03.2010 8:22:34 Uhr