Filter
Top Products
21
Our products are designed to meet the
highest standards of quality, functionality and
design. We hope you enjoy your new Braun
shaver.
Warning
Your shaver is provided with a low voltage
adapter. Therefore you must not exchange or
manipulate any part of it. Otherwise there is a
risk of electric shock.
Description
1 Shaver foil
2 Cutter block
3 Release button
4 On/off switch
5 Long hair trimmer
6 Charging light (green)
7 Special power supply cord set
Charging the shaver
• When charging for the first time
: Using the
power supply cord set, connect the shaver
to the mains with the motor switched off.
Charge it for at least 4 hours (special cord
adapter and shaver might get warm). Once
the shaver is completely charged, shave
until fully discharged. Then recharge to full
capacity again.
• A full charge will give up to 40 minutes of
cordless shaving time depending on your
beard growth. However, the maximum
battery capacity will only be reached after
several charging/discharging cycles.
• Best environmental temperature range for
charging is 15°C to 35°C.
• When fully discharged, you may also shave
with the shaver connected to the mains via
the power supply cord set.
Indicator lights
The green charging light shows that the
shaver is being charged. When the recharge-
able battery is fully charged, the charging light
goes off. If later on, the charging light comes
again, this indicates that the shaver is being
recharged to maintain its full capacity.
Shaving
Turn on the shaver («start»):
The pivoting cutting system automatically
adjusts to every contour of your face.
Trimmer:
When the long hair trimmer is activated, it
allows the controlled trimming of moustache
or sideburns.
Cleaning
Always unplug the appliance before cleaning.
Regular cleaning ensures better shaving
performance. Rinsing the shaving head after
each shave under hot running water is an easy
and fast way to keep it clean:
• Switch the shaver on (cordless) and rinse
the shaving head under hot running water.
A natural based soap may also be used
provided it contains no particles or
abrasive substances. Rinse off all foam and
let the shaver run for a few more seconds.
• Next switch the shaver off and press the
release button (shaver head must be in
central position). Lift the shaver foil off and
pull the cutter block out. Then leave the
disassembled shaving parts to dry.
Tips for the perfect shave
• We recommend that you shave before
washing, as the skin tends to be slightly
swollen after washing.
• Hold the shaver at right angles (90°) to the
skin. Stretch your skin and shave against
the direction of beard growth.
• To maintain 100% shaving performance
replace your foil and cutterblock every
18 month or when worn.
English
5725452_Flex5765_Japan Seite 21 Montag, 8. Oktober 2007 1:59 13