Filter
Top Products
11
Model 8990:
When the shaver is fully charged, all five
charging lights (16) will light up (20% per light), provided
the shaver is plugged in or switched on.
Model 8986: When the shaver is fully charged, all three
charging lights (16) will light up, provided the shaver is
plugged in or switched on.
Model 8985: The green single charging light (16) shows
that the shaver is being charged. When fully charged, the
charging light flashes or turns off. If later on, the charging
light turns on again, this indicates that the shaver is being
recharged to maintain its full capacity.
Charging information
A full charge will give up to 50 minutes of cordless shaving
time, depending on your beard growth.
Best environmental temperature range for charging is
60°F to 75°F/15 °C to 35°C.
For battery maintenance, the system will automatically
initiate full discharging and then recharging of the
batteries. This will take place every six months at the
most, and only if necessary.
Replacement light for shaving parts/Reset
To maintain 100% shaving performance, replace your foil
and cutter block, when the replacement light for shaving
parts (18) comes on (after about 18 months) or when worn.
Change both parts at the same time for a closer shave with
less skin irritation.
(Shaver foil (10) and cutter block (11): 8000 series)
The replacement light will remind you during the next
7 shaves to replace the shaving parts. Then the shaver
will automatically reset the display.
After you have replaced the shaving parts (foil and cutter
block), use a ball-pen to push the «reset» button (19) for at
least 3 seconds to reset the counter.
While doing so, the replacement light blinks and goes off
when the reset is complete. The manual reset can be done
at any time.
0...20
40
60
80
100
replace foil+cutt
e
replace foil+cut
t
replace foil+cu
tt
empty
charge
8000
Series
360°Complete
0...20
40
60
80
e
t
replace foil
5647446_8990_86_S4-34 Seite 11 Freitag, 17. März 2006 8:56 08