Filter
Top Products
6
Shaving
7
• Take off the foil protection cap
9
.
• For shaving, push the switch
4
to setting «1».
• Hold the shaver at right angles (90°) to the skin
.
• Stretch the skin with your free hand.
• Guide the shaver smoothly against the direction of
beard growth, applying only gentle pressure.
The pivoting cutting system (twin foil
H
and
integrated longhair cutter
h
follows the contours of
your face automatically.
Cleaning and maintenance
Switch the shaver off.
After each shave take off the tri
ple shaving frame
8
.
Press the button
j
to release the triple shaving
frame and pull it off.
Tap out sli
ghtly the triple shaving frame. Do not clean
the twin foil
H
with the brush.
Clean the duo cutterblock
7
thoroughly with the
brush.
Move the duo cutterblock crosswise and take it off.
Brush out the entire pivoting head area, including the
cutterblock base
6
. After cleaning place the duo
cutterblock back into the cutterblock base
6
and
replace the triple shaving frame
8
until it clicks into
place.
Approximately every four weeks clean the duo
cutterblock
7
with Braun cleaning agents.
After every cleaning replace the foil protection
cap
9
.
While shaving difficult parts of your face (e. g. under
the nose or at the hairline), push switch
4
to setting
«2», to lock the pivoting head at an angle.
Longhair trimmer
5
To activate the longhair trimmer, move the switch
4
to setting «3». The longhair trimmer moves upwards
and allows easy and exact trimming of the side
burns.
Switching the shaver off
Move the switch
4
back to setting «0».
Im
portant: After every shave, put the foil protection
cap
9
on the pivoting head.
The triple shaving frame and duo cutterblock are
precision parts that will wear out over time. To
maintain optimal shaving performance you should
replace these parts when worn. This will ensure that
you continue to get the close, comfortable shave you
expect from your Braun shaver.
Im
portant: Buy only original Braun spare parts,
especially when replacing the cord or the triple
shaving frame
8
. When replacing the triple shaving
frame look for the brand. Only this way you will
obtain a perfect shave.
Tri
ple shaving frame
8
: Remove as described under
«Cleaning and maintenance». Set the new triple
shaving frame on the pivoting head until it clicks into
place. Handle with care.
Duo-cutterblock
7
: Take as described under
«Cleaning and maintenance». Place the new duo
cutterblock into the cutterblock base
6
until it clicks
into place.
Purchasing spare parts