Filter
Top Products
6
Your Braun Syncro is supplied with a
Braun Clean&Charge (please see separate
use instructions).
Important
Only use the power supply cord set provided.
A damaged cord must be replaced immediately.
Description
1 Foil protection cap 6 Switch
2 Shaver foil 7 Display
3 Cutter block 8 Info key
4 Foil release button 9 Pilot light
5 Long hair trimmer 10 Shaver socket
Technical specifications:
•
Wattage via cord set: 7 W
•
Power supply via cord set:
100-240 V
2
/50 or 60 Hz (automatic adaptation)
•
Shaver input voltage: 12-24 V
Charging the shaver
•
First charging: Using the power supply cord set,
plug the shaver into an electrical outlet with the switch
on position «0» and charge it for at least 4 hours
(plug might get warm).
•
Once the shaver is completely charged, shave without
the cord until fully discharged. Then recharge to full
capacity again (subsequent charges will take about
1 hour).
•
A full charge will give up to 50 minutes of cordless
shaving time depending on your beard growth.
However, the maximum battery capacity will only be
reached after several charging/discharging cycles.
•
Best environmental temperature range for charging
is 60°F to 95°F / 15°C to 35°C.
+35°C
+15°C
210
7570
5491451_S 4-29 Seite 6 Freitag, 18. August 2000 11:19 11