Filter
Top Products
18
Contour Trimming / Styling
• The wide trimmer (2) evenly cuts and trims large areas. It is ideal for
shaping sideburns, moustaches and partial short beards. Take off the
comb. While stretching the skin, guide the wide trimmer against the
direction of hair growth (b).
• The precision trimmer (3) (model cruZer6 beard&head only) precisely
defines lines and edges and is ideal for precise contouring. To use the
precision trimmer, press the release button (4) and slide it up (c).
Hair cutting (model cruZer6 beard&head only)
The hair should be clean, well combed, tangle-free and dry.
• Place the hair comb (1b) on the appliance with the appliance turned off (d).
• Press the length selector (6) and slide the hair comb up to your desired
hair length (possible length settings: 10, 12, 14, 16, 18, 20 mm). If you are
not used to clipping hair, begin with a highest setting and then reduce the
setting to avoid cutting more hair than desired. If you want to cut your hair
shorter than 10 mm, we advise to first cut it with the hair comb (1b) down
to 10 mm and then use the beard comb for the desired length.
• Use a slow and controlled movement. Do not force the appliance through
the hair faster than it can be cut.
• In between, shake or blow off the hair. If too much hair is caught in the
comb, remove and clean it.
Cleaning
The appliance is suitable for cleaning under running tap water.
Warning: Detach the appliance from the power supply before
cleaning it with water.
Regular cleaning ensures better trimming performance.
Cleaning with the brush
• Switch off the appliance. Open the wide trimmer by pressing with the
thumb against the trimmer from the front side. It opens by ca. 45° and can
also be taken off (h).
• Using the brush clean the trimmers and the space behind the wide
trimmer (inside the housing).
Cleaning with water
• Switch off the appliance and rinse the head and trimmers under warm
running water. You can also rinse the opened wide trimmer.
• Leave the appliance with opened wide trimmer to dry.
92010245_beard-head_MN_S6-20.indd 1892010245_beard-head_MN_S6-20.indd 18 16.09.11 09:3116.09.11 09:31