Braun 510 Electric Shaver User Manual


 
8
Description
1 Shaver foil
2 Cutter block
3 Foil release buttons
4 Long hair trimmer
5 Comfort setting switch «sensitive»
6 On/off switch
7 Shaver power socket
8 Special cord set
9 Case
Shaving
Press the on/off switch (6) to operate the
shaver.
Comfort setting switch «sensitive»
Setting the shaver head according to your
comfort needs.
The «sensitive» switch (5) provides three
options for comfort setting:
1 « + » :
The shaver head is in full swing, freely
follows the contours of your skin to
provide more comfort.
2 middle position:
The shaver head is semi-fixed for more
control.
3 « – » :
The shaver head is fixed for full control
and precise handling in hard to reach
areas.
Long hair trimmer
To trim sideburns, moustache or beard, slide
the long hair trimmer (4) upwards.
Tips for the perfect shave
For best shaving results, Braun recom-
mends you to follow 3 simple steps:
1. Always shave before washing your face.
2. At all times, hold the shaver at right
angles (90°) to your skin.
3. Stretch your skin and shave against the
direction of your beard growth.
Cleaning
The hand-held unit should be detached from
the power supply cord before cleaning. The
shaver should not be used until it has dried.
Regular cleaning ensures better shaving
performance. Rinsing the shaving head under
running water after each shave is an easy
and fast way to keep it clean (A):
Rinse the shaver head under hot running
water. You may use liquid soap without
abrasive substances. Rinse off all foam.
Next, press the foil release buttons (3) to
remove the shaver foil (1) and cutter block
(2). Then leave the disassembled shaving
parts to dry.
If you regularly clean the shaver under
water, then once a week apply a drop of
light machine oil onto the long hair trimmer
and shaver foil.
The following quick cleaning is another
alternative cleaning method (B):
Press the foil release buttons (3) to lift
the shaver foil (do not remove the foil
completely). Switch on the shaver for
approx. 5–10 seconds so that the shaved
stubbles can fall out.
Switch off the shaver. Remove the shaver
foil and tap it out on a flat surface. Using
a brush, clean the inner area of the shaver
head. However, do not clean the shaver foil
nor the cutter block with the brush as this
will damage them.
Keeping your shaver in top
shape
Replacing the shaver foil and cutter block
To maintain 100% shaving performance,
replace the shaver foil (1) and cutter block (2)
at least every 18 months or when worn.
Change both parts at the same time for a
closer shave with less skin irritation.
98755137_Cord_510_NA_S6-.indd 898755137_Cord_510_NA_S6-.indd 8 19.08.2008 9:43:37 Uhr19.08.2008 9:43:37 Uhr