Filter
Top Products
Braun Corporation FMVSS No. 403 Quick Reference Installation Sheet 34274 Rev. A
Lift Operating Instructions
STOW
DOWN UP
B
D
A
F
H
J
G
E
In the event of power failure, refer to the Manual Operating Instructions to operate the lift.
TO DEPLOY PLATFORM:
1. Stand Clear and press the UP
switch until the platform stops
(extends fully). Release Switch.
2. Lift handrail latch handles,
deploy handrails up to vertical
position and lower latch handles
fully. See Handrail Operating
Instructions.
3. Lift outer barrier to vertical posi-
tion. See Handrail Operating
Instructions. See Photo B.
4. Latch the handrail belt (see
Photo B).
5. Press the UP switch until the
platform stops (just below the
door opening). Release switch.
6. Open bus door fully.
7. Press the UP switch until the
platform stops (raises to floor
level) and the inner roll stop un-
folds fully to floor level position.
Release switch. See Photo D.
TO UNLOAD PASSENGER:
1. Read Note below! Load pas-
senger onto platform and lock
wheelchair brakes.
Note: Passenger must be
positioned fully inside yellow
boundaries and outer barrier
must be UP.
2. Press DOWN switch until plat-
form stops (just below the door
opening - as shown in Photo G).
Release switch.
3. Close bus door fully.
4. Press the DOWN switch until the
entire platform reaches ground
level and both outer barriers
unfold fully (ramp position).
Release switch. See Photo G.
5. Unlatch handrail belt, unlock
wheelchair brakes and unload
passenger from platform.
Note: Outer barriers must be
fully unfolded (ramp position)
until the entire wheelchair (or
standee has crossed both outer
barriers. See Photos I and J.
TO LOAD PASSENGER:
1. Read Notes below! Load
passenger onto platform, lock
wheelchair brakes and latch
handrail belt.
Note: Outer barriers must be
fully unfolded (ramp position)
until the entire wheelchair (or
standee) has crossed both outer
barriers. See Photos I and J.
Note: Passenger must be
positioned fully inside yellow
boundaries.
2. Press the UP switch to fold both
outer barriers up fully (vertical)
and raise the platform until the
platform stops. Release switch.
Note: Platform will stop just
below the door opening.
3. Open bus door fully. See Photo
N.
4. Press the UP switch until the
platform stops (raises to
floor
level) and the inner roll stop un-
folds fully to floor level position.
Release switch.
5. Unlock wheelchair brakes and
unload passenger from platform.
I
N
Hand-held Pendant Control:
The hand-held attendent's pendant
control is equipped with three push
button switches (STOW, DOWN
and UP). The momentary switches
activate the automatic lift functions.
Simply press the switch labeled for
the intended function. When there is
power to the lift, the lift function labels
illuminate to identify the functions.
PUNWOD
STOW
K
P
L
O
M
Inner Roll Stop at Floor Level
C
OPEN - DOOR - CLOSE
Inner Roll Stop
Lift stops just below door.
Inner Roll Stop at Floor Level
Q
TO STOW PLATFORM:
1. Latch handrail belt. See Photo B.
2. Press the STOW switch until platform stops at stow level. Release switch.
3. Unlatch handrail belt.
4. Fold tall outer barrier down to platform (horizontial) position.
5. Lift handrail latch handles, stow handrails down to platform
(horizontial) position and lower latch handles fully.
6. Press the STOW switch until the platform stops (retracts fully).