Filter
Top Products
9
English
Our products are designed to meet the
highest standards of quality, functionality and
design. We hope you enjoy your new Gillette
Shaver.
Warning
Your shaver is provided with a special cord set
with an integrated Safety Extra Low Voltage
power supply. Do not exchange or manipulate
any part of it. Otherwise there is risk of electric
shock.
Description
1 Shaver foil protection cap
2 Shaver foil
3 Cutter block
4 Release button
5 On/off switch («start/stop»)
6 Long hair trimmer
7 Charging light (green)
8 Cleaning light (yellow)
9 Replacement light for shaving parts
10 Reset button
11 Special cord set
Charging
The best environmental temperature for
charging is between 15 °C and 35 °C.
• First charge
: Using the special cord set,
connect the shaver to an electrical outlet
with the motor switched off and charge the
shaver for at least 4 hours.
• The green charging light blinks when the
shaver is being charged. When the battery
is fully charged, the charging light lights
permanently.
• A full charge provides up to 50 minutes of
cordless shaving time depending on your
beard growth.
• Once the shaver is completely charged,
shave without the cord. With normal use the
shaver will be charged automatically after
every cleaning in the Clean&Renew™
(see separate use instructions).
• Maximum battery capacity will only be
reached after several charging/discharging
cycles.
• Re-charging time in the Clean&Renew™:
8 hours.
• Re-charging time with the special cord set:
1 hour.
• If the rechargeable batteries are discharged,
you may also shave by connecting the
shaver to an electrical outlet via the special
cord set.
Shaving
Turn on the shaver («start»):
The pivoting cutting system automatically
adjusts to every contour of your face.
Trimmer:
When the long hair trimmer is activated, it
allows the controlled trimming of moustache
or sideburns.
Keeping your shaver in top
shape
Cleaning indicator
Your shaver should be cleaned daily in the
Clean&Renew™, and certainly when the yellow
cleaning light (8) shines constantly after shav-
ing. If this is not done, the yellow light will go
out after some time. The shaver`s electronics
will then assume it has been cleaned manually
Tips for the perfect shave
• We recommend that you shave before
washing, as the skin tends to be slightly
swollen after washing.
• Hold the shaver at right angles (90°) to the
skin. Stretch the skin and shave against
the direction of beard growth.
• To maintain 100% shaving performance,
replace the shaver foil and cutter block,
when the replacement light (9) comes on
(after about 18 months), or when the
shaving parts are worn.
5735453_Contour5895_CH390cc Seite 9 Donnerstag, 12. April 2007 11:04 11