Filter
Top Products
4
English
Description
a Oral-B Precision Clean
®
brush head
b Pressure sensor light
c On/off button (mode selection)
d Handle
e Charge indicator light
f Low charge indicator light
g Basic charger
h Brush head holder (depending on model)
i Brush head compartment with protective cover (depending on
model)
Connecting and charging
Your toothbrush has a waterproof handle, is electrically safe and
designed for use in the bathroom.
• Plug the basic charger (g) or the assembled charging unit (see
picture B/C, page 2) into an electrical outlet and place the tooth-
brush handle (d) on the charging unit.
• The green charge indicator light (e) flashes while the handle
is being charged. Once it is fully charged, the green charge
indicator light shines continuously for 5 seconds; then it turns off.
A full charge takes at least 17 hours and enables approximately
one week of regular brushing (twice a day, 2 minutes).
• When the rechargeable battery is low, the red low charge
indicator light (f) starts flashing after turning off the toothbrush.
• For everyday use, the toothbrush handle can be stored on
the charging unit to maintain it at full power. Overcharging
is impossible. However for environmental reasons, Oral-B
recommends to unplug the charging unit until the next charge
is required.
Please note: If the charge indicator light is not flashing immediately,
continue charging. It will appear in 10–15 minutes.
Specifications
For voltage specifications please refer to the bottom of the charging
unit.
Using your toothbrush
Wet brush head and apply toothpaste; you can use any kind of
toothpaste. To avoid splashing, guide the brush head to your teeth
before switching on the appliance. Guide the brush head slowly
from tooth to tooth, spending a few seconds on each tooth surface.
Brush the gums as well as the teeth, first the outsides, then the
insides, finally the chewing surfaces (see picture 5, page 2). Do not
press too hard or scrub.
Brushing modes (depending on model)
«Daily Clean» – Exceptional mouth cleaning.
«Sensitive» – Gentle, yet thorough cleaning for sensitive areas.
«Whitening» – Exceptional whitening for occasional or everyday
use.
How to switch between modes:
• When pressing the on/off button (c) your toothbrush automati-
cally starts in the «Daily Clean» mode.
• To switch to the «Sensitive» and «Whitening» mode, successively
press the on/off button.
• To turn off your toothbrush from the «Whitening» mode, push the
on/off button once more.
• If you wish to turn off your toothbrush from the «Daily Clean» or
«Sensitive» mode, push and hold down the on/off button until the
motor stops.
Pressure Sensor
Helping protect your teeth and gums from hard brushing, your
toothbrush has a pressure control feature installed. If too much
pressure is applied, the red pressure sensor light (b) will light
reminding you to reduce pressure (see picture 3, page 2).
99959719_D20_NA.indd 499959719_D20_NA.indd 4 04.10.2011 13:28:22 Uhr04.10.2011 13:28:22 Uhr