Filter
Top Products
19
Wall mount
If you prefer to mount the SmartGuide display
unit on a wall, mirror or other surface, use the
adhesive tape (m) to fix the wall mount. Before
doing so, make sure the chosen surface is clean
and dry (remove grease and dust first). Position
the wall mount so that the Oral-B logo is
readable. Then press the wall mount evenly and
firmly to the wall. Wait 24h before sliding the
SmartGuide display unit into the fixed wall
mount.
Please note: the adhesive tape will not work on
dirt-repellent surfaces.
Cleaning recommendations
• After brushing, rinse your brush head
thoroughly under running water.
• Remove the brush head from the handle and
clean both parts separately under running
water. Then wipe them dry before you put the
handle on the charging unit.
• Before cleaning your charging unit, make sure
you disassemble it first. The charging ring and
the SmartPlug should never be placed in the
dishwasher. However, all other parts (base
station, base plate and protective cover) are
dishwasher-safe.
• From time to time, you can also clean
the charging ring, the SmartPlug and the
SmartGuide display unit with a damp cloth.
The SmartPlug charger and the SmartGuide
display unit should never be placed in water.
Synchronizing
In order to avoid interference of display
messages when using more than one Braun
Oral-B Denta-Pride toothbrush with separate
SmartGuide display units in the same house-
hold, you need to assign the handles to their
respective display units. Please follow the steps
below:
• Push the «h/min» button in the battery
compartment for at least 3 seconds. The
SmartGuide display unit shows «L---», in-
dicating the «Learn» mode for synchronization
is activated.
• Now you are requested by a flashing on/off
button in the toothbrush icon on the
SmartGuide display unit to turn the handle on.
When doing so, the automatic synchronization
process starts. It is finished when «L-1-» is
displayed.
• Then turn off the handle.
If you would like to assign a second handle to
the same SmartGuide display unit, repeat the
last two steps described above with the other
handle. You can exit the «Learn» mode by
pressing the «h/min» or «set» button. Otherwise
the «Learn» mode will automatically end after
30 seconds.
Please note:
– A maximum of 2 handles can be
synchronized with one SmartGuide display
set
h/min
3 sec.
set
h/min
3 sec.
3738155_D30_Japan/Taiwan.indd 193738155_D30_Japan/Taiwan.indd 19 15.11.2007 10:18:33 Uhr15.11.2007 10:18:33 Uhr