Filter
Top Products
4 Keeping your shaver in top shape
4.1 Cleaning
• After shaving, switch the shaver off. Press the release buttons, take off the
shaver foil (d) and gently tap it out on a flat surface (e).
• Then thoroughly clean the cutter block with the brush (f). About every four
weeks, clean the cutter block with Braun cleaning agents (g).
• Do not clean the shaver foil with the brush.
• If you have a very dry skin and you notice a reduced operation time of the
shaver, you should put a drop of sewing machine oil onto the floating cutter
and shaver foil (g).
4.2 Replacing the shaving parts
• The shaver foil and cutter block are precision parts that, in time, are subject to
wear. A regular replacement of the parts every 1
1
/
2
years or when these parts
are worn, will ensure, that you are getting the close, comfortable and quick
shave you expect from your Braun shaver.
(Shaver foil and cutter block: part no. 3600)
• Press the release buttons, take off the shaver foil. Replace the new shaver foil
in the right direction until it locks in place.
• To remove the cutter block, lift it off (g).
To replace the cutter block, snap onto the holding studs.
4.3 Preserving the rechargeable battery
• In order to optimise the capacity and life of the battery, it should be fully
discharged through regular use every 6 months approximately. Then
recharge to full capacity again. This reconditions the rechargeable battery.
• Do not expose the shaver to temperatures of more than 50°C for long periods
of time.
5 Environmental notice
This appliance is provided with nickel-hydride rechargeable batteries.
To protect the environment, do not dispose of the appliance in the household
waste at the end of its useful life. Open the housing as shown on page 45,
remove and dispose of the batteries at your retail store or at appropriate
collection sites according to national or local regulations.
Subject to change without notice.
This product conforms to the EMC-Requirements as laid down by the
Council Directive 89/336/EEC and to the
Low Voltage Regulation (73/23 EEC)
.
Tips for the perfect shave
• We recommend that you shave before washing, as the skin tends to be
slightly swollen after washing.
• Hold the shaver at right angles (90°) to the skin.
• Stretch your skin and shave against the direction of beard growth.
• Replace the shaver foil and cutter block every 1
1
/
2
years, or when the parts
are worn, to ensure optimum shaving performance.
8
5629480_S4-46 Seite 5 Mittwoch, 24. Januar 2001 3:10 15