Braun 3535 Hair Dryer User Manual


 
English
Carefully read the use instructions
before use.
Important
Plug your hairdryer into analte-
rnating current (~) outlet only and
be sure that your household
voltage corresponds to the
voltage marked on the hairdryer.
Do not allow the ap-
pliance to become wet.
When using the hairdryer in a
bathroom, always unplug it after
use. Even a switched-off
hairdryer presents a hazard if not
unplugged.
For additional protection, it is
advisable to install a residual
current device (RCD) with a rated
residual operating current not
exceeding 30 mA in the electrical
circuit of your bath-room. Ask
your installer for advice.
Care should be taken not to block
the inlet and outlet grill when the
hairdryer is switched on. If either
grill becomes blocked, the hair-
dryer will automatically cut out.
After cooling for a few minutes, it
will switch back on automatically.
Do not wrap the mains cord
around the appliance. Regularly
check the mains cord for wear or
damage, particularly where it
enters the product and the plug.
If you have any doubt about its
condition take the appliance to
your nearest Braun Service
Centre for checking/repair.
The mains cord of the appliance
may only be replaced by an
authorized Braun Service Centre.
Unqualified repair work can lead
to extreme hazards for the user.
Switch 1
0 = off
1 = gentle drying
2 = fast drying
Cord storage 2
The cord can be stored
conveniently in the handle.
Subject to change without notice.
3533054_A1000 Seite 3 Donnerstag, 7. Dezember 2006 12:08 12