Filter
Top Products
11
• Push the start/release button (1) to lock and connect the shaver. The
cleaning process will start. The yellow light on the shaver will flash during
the complete process.
• Do not interrupt the cleaning process, as it leaves the shaver wet and not
fit for use. If interruption is needed nonetheless, press the start/release
button (1).
• When cleaning is finished, the yellow light will go off. Leave the shaver in
the station for drying. It takes several hours until remaining moisture
evaporates depending on the climatic conditions. Afterwards the shaver is
ready for use. To release it, push the start/release button.
• A cleaning cartridge should be sufficient for about 30 cleaning cycles.
When the level indicator (4) has reached the «
» mark, the remaining fluid
in the cartridge is sufficient for about 5 more cleaning cycles. Then the
cartridge should be replaced, when used daily approx. every 4 weeks.
• The hygienic cleaning solution cartridge contains izopropanol which, once
opened, will naturally evaporate slowly into the surrounding air. Each
cartridge, if not used daily should be replaced after approx. 8 weeks.
• The cleaning cartridge also contains lubricates, which may leave residual
marks on the shaver head after cleaning. However, these marks can be
removed easily by wiping gently with a cloth or soft tissue paper.
• Clean the housing from time to time with a damp cloth, especially the
opening where the shaver rests.
Accessories
Available at your dealer or Braun Service Centres:
• Foil & Cutter cassette: 32S/32B
• Cleaning cartridge Clean&Renew: CCR
Subject to change without notice.
For electric specifications, see printing on the special cord set.
Please do not dispose of the product in the household waste at the
end of its useful life. Disposal can take place at a Braun Service
Centre or at appropriate collection points provided in your country.
92331049_390cc_RU-UA_S6-32.indd 1192331049_390cc_RU-UA_S6-32.indd 11 10.07.12 16:0010.07.12 16:00