Braun 2560 Electric Shaver User Manual


 
6
English
Our products are designed to meet the highest standards of quality, functionality
and design. We hope you entirely enjoy your new Braun shaver.
Caution
Do not use the shaver near, or over, basins filled with water (e.g. bath tubs, showers
etc.).
For safety reasons, periodically check the cord for damage and replace it, if it is
loose in the shaver socket.
1 Description
1
Foil protection cap
6
On/off Switch
2
Foil frame
7
Longhair trimmer switch
3
Cutter block
8
Charging light
4
Longhair trimmer
9
Shaver socket
5
Switch lock
2 Charging the shaver
For the 3 first chargings: Connect the shaver to the mains and charge it for at least
4 hours (switch position «off»). After the cell unit is fully charged, the green charging
light goes off. If later on, the charging light comes on again, this indicates that the
shaver is being recharged to maintain its full capacity.Then shave without the cord
until the shaver runs distinctly slower. The full capacity is reached after several
charge/discharge cycles.
Wattage: 5 Watts
Voltage range during charging: 12 – 240 V
ȃ
/ 50 or 60 Hz (automatic adaption)
Best environmental temperature range for charging: 15 °C to 35 °C
Charging cord as of 12 V (for boat or car, available from your dealer or at Braun
Service Centres, No. 5-001-687). Recharging with this cord takes about 20 hours.
3 Shaving
3.1 Switch lock
The shaver is delivered with the switch lock activated (position «lock»). Push the
switch lock up before you shave for the first time. To avoid accidentally switching
the shaver on, e. g. when travelling, push the switch lock to position «lock».
3.2 Switch positions
off
on = Normal shave
longhair trimmer = The longhair trimmer is activated
for exact trimming of sideburns, moustache and beard (d),
combination shave (simultaneous use of longhair trimmer and shaving foil) (c).
First, the longhair trimmer cuts off the longer «problem hairs», then the foil
follows to give a close, smooth shave.
3.3 Shaving with the cord
If the cell unit is discharged, you may also shave with the shaver connected to the
mains (100 – 240 V
ȃ
). (If the shaver should not run immediately, charge it with the
switch on position «off» for approx. 1 minute.)
5596076_S.4-58.fm Seite 6 Dienstag, 13. November 2001 12:01 12