Filter
Top Products
10
6 Thoroughly clean the tweezer element
with the cleaning brush and also with
alcohol. While cleaning, you can turn
the tweezer element manually. To
remove the epilation head, press the
release buttons
3
on the left and right
and pull it off.
7 Give the top of the housing a quick
clean with the brush. Replace the
epilation head and the EverSoft
attachment.
B Shaving
1 Remove the OptiTrim attachment
H
.
Put on the shaver head by clicking it
in (the long hair trimmer should be in
front).
2 When using the shaver head, always
slide switch up to setting «2».
3 For best results, guide the shaving
system in a way that about half of
the shaving foil and the trimmer are in
contact with your skin. Always guide
the appliance in the direction of the
trimmer. The trimmer first raises all
long hairs and cuts them off. Then the
flexible foil follows to smooth away any
stubble.
Pre-cutting hair for epilation
4 When using the shaver head to pre-cut
your hair to the ideal length for epila-
tion, put on the OptiTrim attachment.
5 Hold the appliance with the OptiTrim
attachment ensuring that the surface
of the comb is lying flat on the skin.
Guide the appliance with the comb
tips against the hair growth as shown
in illustration B5.
Important:
As hair does not always grow in
the same direction, it may be difficult to
cut. In which case, guide the appliance
slightly diagonally or in different direc-
tions.
Cleaning the shaver head
6 After shaving, unplug the appliance
and, if necessary, remove the OptiTrim
attachment.
7 Clean the OptiTrim attachment with the
brush.
8 In order to clean the shaver head,
remove the shaving foil frame.
To do so, press the release bars on the
front and back and pull it off.
9 Carefully tap the shaving foil frame on a
flat surface.
10 Brush out the cutter block as well as
the area below the cutter block.
11 Caution: The shaving foil is a very
delicate part that must not be cleaned
with the brush.
12 We recommend that you oil the trimmer
every 3 months with a drop of sewing
machine oil.
13 Put the shaving foil frame back on and
snap it into place.
14 Replace the OptiTrim attachment
because it also serves as a protective
cap.
Caution:
Do not use the shaver head with
a damaged shaving foil.
Replacing the shaving parts
The shaving foil and the cutter block are
precision parts that wear out with the time.
Have the shaving foil frame and the cutter
block replaced when you notice a reduced
shaving performance.
Subject to change without notice.
5317420_2370_NA_P6-28 Seite 10 Dienstag, 18. Dezember 2001 1:07 13