Filter
Top Products
7
Cleaning
This appliance is suitable for cleaning under an open water tap.
Warning: Detach the hand-held part from the power supply before
cleaning it in water.
Regular cleaning ensures better shaving performance (b).
• After each shave, rinse the shaving head under hot running water.
A natural based soap may also be used provided it contains no particles
or abrasive substances. Rinse off all foam.
• Lift the shaver foil off and pull the cutter block out. Then leave the
disassembled shaving parts to dry.
• If you regularly clean the shaver under water, then once a week apply a
drop of light machine oil onto the long hair trimmer and shaver foil.
Alternatively, you may clean the shaver using the brush provided (c).
• Lift the shaver foil off.
• Using the brush, clean the cutter block and the inner area of the shaver
head. However, do not clean the shaver foil with the brush as this may
damage the foil.
Keeping your shaver in top shape
About every four weeks, clean the cutter block with Braun cleaning agents.
Replacing the shaving parts
To maintain 100% shaving performance, replace your foil and cutter block
at least every 18 months or when worn. Change both parts at the same time
for a closer shave with less skin irritation.
(Shaver foil and cutter block: 10B)
Subject to change without notice.
This product conforms to the European Directives EMC 2004/108/EC
and Low Voltage 2006/95/EC.
For electric specifications, see printing on the special cord set.
Please do not dispose of the product in the household waste at the
end of its useful life. Disposal can take place at a Braun Service Centre
or at appropriate collection points provided in your country.
5727353_Series1_170_AMEE Seite 7 Donnerstag, 31. Mai 2007 10:50 10