Filter
Top Products
18
EN
Adding/removing laundry in standby
mode
In order to add or remove laundry after the
programme starts:
1. Press the “Start/Pause/Cancel” button to
switch the dryer to “Pause” mode. Drying
process will stop.
2. Open the door at “Pause” position and
close it again after adding or taking out
laundry.
3. Press “Start/Pause/Cancel” button to start
the programme.
C Any laundry added after the drying process
has started may cause the dried clothes in
the machine intermingle with wet clothes
and the result will be wet laundry after the
drying process is over.
C Laundry may be added or taken out
as much as desired during a drying
process, but this process will extend the
programme duration and increase energy
consumption since the drying will be
interrupted continuously. Therefore, it is
recommended to add laundry before the
drying programme has started.
Child-proof lock
There is a child-proof lock to prevent any
programme interruption due to the pressing of
button while the programme is running. The
loading door and all buttons except the “On/
Off” button on the control panel are deactivated
when the child-proof lock is active.
Press the “Start/Pause/Cancel” and “Cancel
audio warning” buttons simultaneously for 3
seconds to activate the child-press lock.
To start a new programme after the programme
is over or to interrupt the programme, the child-
proof lock should be deactivated. Press the
same buttons for 3 sec. again to deactivate the
child-proof lock.
C Child-proof lock is deactivated when the
machine is restarted by pressing the On/Off
button.
C Press the relevant buttons for 3 seconds
to activate the child-proof lock. A long
beep will be heard and the child-proof lock
will be activated. A double beep will be
heard if you press any button or turn the
programme selection knob while the child-
proof lock is active. Press the buttons for 3
seconds to deactivate the child-proof lock.
Single beep will be heard and child-proof
lock will be deactivated.
A A double beep will be heard if you turn
the programme selection knob when the
machine is running and the child-proof lock
is active. If you deactivate the child-proof
lock without returning the programme
selection knob to its previous position, the
programme will be terminated since the
position of the programme selection knob
is changed. The drying light turns on and
the machine remains on hold until a new
programme is selected and the “Start/
Pause/Cancel” button is pressed.
Finishing by cancelling the
programme
To cancel any selected programme:
Press “Start/Pause/Cancel” button for about 3
seconds. The “Filter cleaning”, “Water tank” and
“End/ Anti-creasing” warning lights will turn on
at the end of this period for reminding purposes.
A As the inside of the dryer will be excessively
hot when you cancel the programme while
the dryer is running, activate the ventilation
programme to cool it down.