Filter
Top Products
BATTERY INSTALLATION
NOTE: The word Lo by itself does not mean the battery is low and
needs to be changed. It means the temperature being measured is
out of the thermometer’s range.
Replace the battery when the low battery
warning symbol appears (See Fig. 1). If
only the symbol appears, you may still
use the thermometer but you will need to
replace the battery soon. If the symbol
appears with the word Lo (See Fig. 2),
you must replace the battery to use the
thermometer.
1. Slide the battery
compartment lid off.
2. Carefully release the battery
by using a non-metal tool
3. Insert one 3-volt CR-2032
lithium battery with the the
positive side (+) facing up.
4.
Replace the battery compartment
lid by sliding it forward.
INSTRUCTIONS FOR USE
Please do not use this ear thermometer when the ear canal is wet.
1. Press and realease the POWER/SCAN
button. The system will start its self-
testing cycle (See Fig. 4).
2. Once the self-testing is completed
(approximately 1 second), the
thermometer will beep twice and the
display will show the last temperature
recorded. This indicates the thermometer
is ready to take a temperature (See Fig. 5).
3. Press the POWER/SCAN button again
and do not release it. The symbol
will appear beneath the last reading
(See Fig. 6). The word Lo may also
appear indicating the temperature
registering is lower than 93.2°F/34°C.
NOTE: The word Lo does not mean the
battery is low and needs to be changed
unless the low battery icon appears with
it (See Fig. 7). It means the
temperature being measured is out of
the thermometer’s range.
4. Keeping the POWER/SCAN button
depressed, insert the probe into the ear
canal. The probe must be inserted well
into the ear to allow the probe tip to
continuously scan the ear canal. This
will ensure an accurate temperature
measurement (See Fig. 8).
5. After one second you will hear a beep
indicating the reading is complete.
Remove the thermometer from the ear
and release the POWER/SCAN button to
get the temperature reading.
6. A smiling face will appear
indicating a temperature reading lower
than 100.4°F/38°C. A frowning face
accompanied by one long and two
short beeps, will indicate a temperature
of 100.4°F/38°C or higher (See Figs. 9
and 10).
7. To change the reading from Celsius to
Fahrenheit, press the POWER/SCAN
button without releasing it, then press
the blue M button on the underside of
Figure 7
Figure 1
Figure 3
Figure 4
Figure 8
Figure 2
Figure 5
Figure 6
Figure 9
Figure 10