Filter
Top Products
Body fat measurement:
Select user USER0 to 10 and then press SET (for less than 1 second) and you are in Standby Mode
(Fig5).
By following the instructions given in Fig.6 and Fig.7, measurement starts when you have both hands
touch the electric panel. The result will be displayed in about 5 seconds. Please refer the Fig. 8 for
fat rate and water level as Fig. 9. Both data will flash alternatively every 2 seconds.
If would like to recall previous data , press
button to fix user (USER 1 to 10 ) then press button,
you may know your stored memory In the device. See Fig10 and Fig. 11 performed by LCD display
alternatively. If all 10 memories are full, the oldest data will be replaced.
(3) Alarm clock mode
Start Alarm Mode:
press
button you may select to open or close alarm.
How to set up alarm:
In Time Mode press MODE twice to enter into the Alarm Mode. Hold SET button for 2 seconds, to
enter hour setting. To set hours, press
/ to change hour. After the setting, press SET to enter
minute setting. Press
/ to change minute and press SET to save the settings.
9