Bodyline Products International AX-5330 Electric Shaver User Manual


 
Axis Air |26| english
Axis Air |27| english
thoroughly.
4. Attach the outer foil frame securely to the body case, and be very
careful not to touch the outer foil.
It is recommended that inner blade be cleaned with the brush at least
once every three (3) washings.
Cleaning with the brush
1. Before cleaning your shaver, be sure to slide the power switch off,
and press both the outer foil frame release buttons on the side at the
same time to remove the outer foil frame.
2. Push the two outer foil unit release knobs inside the outer foil frame
from both sides with fingers, and remove the outer foil unit.
3. You can clean the inside of the outer foil, the inside of the outer foil
unit, the inner blade and the body of the shaver with the accessory
brush.
* To remove the inner blade, pull it straight upwards.
* Do not touch the sharp edges of the blade portion of the inner blade.
* Do not press hard against the inner blade. Doing so may deform
or damage it, which typically produces a poor shave and an unusual
noise.
4. After cleaning, attach the outer foil unit securely to outer foil frame.
Make sure you do not touch the outer foil.
5. Then, attach the inner blade to the vibrator. Set the outer foil frame
securely to the body, and check that it is well secured on the body.
If the outer foil for FINE mode is in a pushed-up position, push its both
ends lightly to reset it in position, and then, reinstall the outer foil frame.
If the shaver is used with the outer foil frame incorrectly set to the