Filter
Top Products
4
Use the chart to find the approximate lengths of cut. Different blade angles in
relation to the skin, thickness and texture of the hair will vary the cutting length.
USER MAINTENANCE
The internal mechanism of your motor clipper has been permanently lubricated
by the factory. Other than the recommended maintenance described in this
manual, no other maintenance should be performed, except by Andis Company,
or an Andis Authorized Service Station. To find an Andis Authorized Service
Station near you log on to www.andis.com or contact our customer service
department: 1-800-558-9441 (U.S.) or 1-800-335-4093 (Canada).
REMOVING BLADE SET
To remove blade set, first make sure your clipper is switched OFF and UNPLUGGED.
Push down on blade, then gently pull the blade forward (Figure C), and slide it
off the blade hinge. If your blade hinge should snap closed and is flush with the
clipper, use a small standard screwdriver to pry the tongue of the hinge out
(Figure D). NOTE: Hair may accumulate in the front cavity of the housing under
the blade. If this happens, you can clean out the hair by brushing out the cavity
with a small brush or an old toothbrush while the blade is off the clipper.
REPLACING OR CHANGING BLADE SET
To replace or change your blade set, slide the blade bracket onto the hinge of
the clipper (Figure E) and with the clipper turned ON, push the blade towards
the clipper to lock into position.
CLIPPING GUIDE
Approximate Length of Cut
Description Clipping Direction Fine Coarse
Standard Andis Blade With hair grain 1/16" to 3/16"
Against hair grain 1/32" to 1/8"
1/8" Blade Attachment With hair grain 1/4" to 3/8"
Against hair grain 1/8" to 1/4"
1/4" Blade Attachment With hair grain 3/8" to 1/2"
Against hair grain 1/4" to 3/8"
3/8" Blade Attachment With hair grain 1/2" to 5/8"
Against hair grain 3/8" to 1/2"
1/2" Blade Attachment With hair grain 5/8" to 7/8"
Against hair grain 1/2" to 5/8"