American Standard T064.60X Bathroom Aids User Manual


  Open as PDF
of 4
 
1
INSTALL DIVERTER
When finished tiling the wall, remove PLASTER GUARD (1).
Remove two screws that secure the DIVERTER LID (2) and
remove Lid. Inspect the inside surface of diverter port.
Diverter port must be free of any dirt. Clean if necessary.
Install DIVERTER (3) with SCREWS (4) removed with
DIVERTER LID (2).
Operate DIVERTER (3). DIVERTER (3) should slide in
and out smoothly.
1
4
3
DIVERTER
PORT
2
INSTALL VALVE TRIM
Figure 1. Push CAP (1) over VALVE CARTRIDGE (2) until
seated against stop. Push CAP (3) over DIVERTER (4) until
seated against stop.
Figure 2. Push ESCUTCHEON HOLDER (5) onto CAP (1)
and attach to valve body with SCREWS (6). Mount
ESCUTCHEON SUPPORT (7) to ESCUTCHEON HOLDER (5)
with SCREWS (8).
Figure 3. Install ESCUTCHEON (9) onto CAP (1) and push
flush against finished wall. Escutcheon (9) will snap fit onto
ESCUTCHEON SUPPORT (7).
1
2
3
4
1
1
Figure 1.
Figure 2.
Figure 3.
2
M968836 Rev.1.4
5
6
9
7
8
7
 previous next