Filter
Top Products
754731-100 Rev. D
2
INSTALLATION AND FRAMING INSTRUCTIONS:
A.) Locate studs as required. Ensure roughing-in dimensions are proper, plumb, and square. It is strongly recommended that
an additional opening be provided for access to the drain components.
B.) As shown in ILL. 2, mark the position of the underside of the deck by tracing a line onto the studs at the height indicated,
using a level or other suitable straight edge.
C.) With the top of the stringer touching the traced line, attach the stringer to the studs.
D.) Install drain components to the bath following the manufacturer's instructions. See the roughing-in drawing for
suggested opening size and location dimensions.
1
ILLUSTRATION 1
ILLUSTRATION 2
6032 Series Tub
18-3/4" (476mm)
17-3/4" (451mm)
6032 Series Seated
Shower Base
DIM A
STRINGER HEIGHT
29-3/4" (756mm)
30-1/2" (775mm)
DIM B
STRINGER LENGTH
A
B
Each alcove
stud must be
plumb and
square.
1. BATH MAY ONLY BE INSTALLED IN A RECESS TYPE INSTALLATION.
2. THIS BATH IS NOT SELF-SUPPORTING AND MUST BE SUPPORTED ALONG ITS ENTIRE
BOTTOM WITH MORTAR OR GROUT. STRINGERS WILL HELP LEVEL TUB, BUT WILL NOT
PROVIDE ADEQUATE SUPPORT.
3. TAKE EXTRA CARE WHEN DRIVING NAILS OR SCREWS TO AVOID DAMAGING THE BATH.
GENERAL INSTALLATION INFORMATION ...