American Standard 2938 Bathroom Aids User Manual


 
754532-100 Rev. A
35
Operation: Single Speed Whirlpool
BATHING:
• Fill bath with water at a comfortable bathing temperature - If your whirlpool is equipped with the
optional EZ-Heater, it will automatically maintain the water temperature.
• IMPORTANT: Do NOT fill the whirlpool more than 2/3 full before getting in, as it may overflow.
• IMPORTANT: Do NOT add bath oils or salts – this will damage the whirlpool pump.
• IMPORTANT: Water level must be at least one inch (25mm) above the highest jet before the whirlpool is started.
Operating the system without water (dry running) for extended periods will cause pump damage and void the warranty.
IMPORTANT: The EcoSilent whirlpool will NOT operate unless the water level is at least one inch above
the highest jet.
STARTING WHIRLPOOL:
• Press on/off button to start whirlpool.
STOPPING WHIRLPOOL:
• Press on/off button again to stop whirlpool.
AIR VOLUME CONTROL ADJUSTMENTS:
• Water turbulence is determined by the amount of air mixed with the water. Rotate the air volume control
counterclockwise for more turbulence, and clockwise for less.
FLOW JET VOLUME ADJUSTMENTS:
• Water flow-levels can be adjusted from vigorous to soft by rotating the nozzle counterclockwise for vigorous and
clockwise for soft.
The water flow to the mini-jets in the lumbar area of bath (if so equipped) can be adjusted by turning the mini-jet
flow control valve open (counterclockwise) or closed (clockwise). the mini-jets themselves are NOT adjustable.
AIR SWITCH ELECTRONIC SWITCH