Filter
Top Products
E-19
A&D Medical (Toll-Free): 1-888-726-9966
E-20
In Canada - Auto Control Medical (Toll-Free): 1-800-461-0991
ADJUSTING THE SPEAKER VOLUME USING THE MONITOR WITH AC ADAPTER
1. Press the
VOLUME
button to enter the
volume adjustment mode. Six stages of
volume, which are represented by bars, and
OFF are available.
2. Press the
button to increase the volume,
or press the
button to decrease the
volume.
3. Press the
START
button to turn the device
off. After three minutes of non-operation,
the device will turn off automatically.
SELECTING THE LANGUAGE
1. In the volume adjustment mode, press the
VOLUME
button to enter the language selection
mode. The current setting appears.
2. Press the
or button to select a language
from the following.
L1: English (default value)
L2: French
L3: Spanish
3. Press the
START
button to turn the device off.
After three minutes of non-operation, the
device will turn off automatically.
High
Low
Volume off
The current setting appears
or to change the volume
press
The current setting appears
or to change the language
High
Low
Volume off
The current setting appears
or to change the volume
press
The current setting appears
or to change the language
The UA-1030T has an AC adapter jack to allow you to supply power from an
outlet in your home. We recommend you only use the exclusive AC adapter
to avoid potential damage to the monitor. Please contact A&D Medical at
1-888-726-9966 or if you are in Canada contact AutoControl at 1-800-461-0991, if
you would like to purchase an additional AC adapter.
CONNECTING THE AC ADAPTER TO THE MONITOR:
1. Gently insert the AC adapter plug into a 120V AC outlet.
2. Connect the AC adapter plug into the jack on the back of the monitor.
DISCONNECTING THE AC ADAPTER FROM THE MONITOR:
1. Turn the unit off by pressing the START button.
2. Disconnect the plug from the jack of the monitor quickly.
3. Gently remove the AC adapter from the outlet.
NOTE: If monitor has batteries and an AC adapter connected, the measurements stored
in memory may be lost if AC adapter is unplugged from the wall first. To ensure that
measurements remain in memory, make sure the unit is off and that the jack plugged
into the monitor is removed quickly before unplugging adapter from the wall.
Jack
Plug
AC Adapter
TB-233