Filter
Top Products
13
6. INSTALLING THE PRINTER PAPER
(This chapter is applicable only to the TM-2655P.)
With the power turned on, install the printer paper as follows:
1. Cut the top end of the printer paper with scissors. If the end is
not smooth, it may cause a paper jam or damage the printer
head.
2. Press lightly on the center of the printer cover to open the
cover.
3. Raise the lever located on the right side of the printer. Insert
the printer paper into the paper feed slot as shown. The paper
is fed automatically.
4. Press the PAPER FEED switch to feed the paper by 10 cm.
Confirm that the paper is fed straight. If not, re-install the paper
because it may cause a paper jam.
5. Lower the lever and feed the paper. The paper will be cut
automatically.
6. Close the cover. Press lightly on the center of the printer cover
to secure it in position.
Note
z With high-speed printing, about 700 printings can be
performed. With three-line printing, about 600 printings.
z Replace the printer paper when the red end is reached.
z Use the specified thermal paper, which is sold separately.
Fig.11 Paper installation procedure