Filter
Top Products
D. Press the OFF and MODE keys simultaneously until display shows “CAB”, then release. The scale
is now calibrated. The display should read the same as the calibration weight being used.
5. CAUTIONS
a. Never leave a load on the scale for a prolonged period of time as this may damage the loadcell
b. Always place a load gently onto the platform. Dropping the weight on may cause PERMANENT
DAMAGE to loadcell.
c. Never try to disassemble the scale, which may PERMANENTLY DAMAGE the mechanism and
electronic components. There are no user serviceable parts inside the scale. Maintenance should
be done by properly trained technicians.
d. For maximum accuracy, place loads as near to the center of the platform as possible.
e. Do not expose the scale to direct sunlight or store in high humidity. Serious jarring of the scale
should be avoided.
If your scale reads “E” or “-EE”
Sometimes an electronic scale can be shifted out of its working range, possibly by a jolt in shipping or
transportation. When this occurs, your scale tells you by displaying. “EE” or “-EE”. This can be
corrected:
1. Press “OFF” and “TARE” simultaneously. The display will show “In” meaning input. You will
be able to input the info needed to get the scale back to its normal function.
2. Press “OFF” and “TARE” simultaneously a second time; a number will appear that will count
down, pause for a few seconds, and eventually stop at a final number.
3. Press “TARE” AND the scale will display zero.
4. Place the calibration weight* onto the scale and press “OFF” and “MODE” simultaneously until
“CAb” appears on the display. A number will then appear, but not the actual weight of the
calibration weight.
5. Remove the calibration weight from the scale and turn off the scale to get out of the input
function. The scale now can be turned back on and should be calibrated normally. At this point,
you should be back in business.
If this procedure does not work the first time, we suggest you keep trying.
PV-60 = 50g calibration weight
PV-100 = 50g calibration weight
PV-200 = 100g calibration weight
PV-500 = 200g calibration weight
A&D Engineering, Inc. (“A&D”) warrants this product to be free from defects in materials and
workmanship, and to conform to its published product specifications, under normal use and service, for the
period of one year commencing from the date of purchase.
The foregoing warranty is extended only to the first purchaser and applies only to product failures due to
defective materials and/or workmanship. Without limiting the generality of the foregoing, the foregoing
warranty will not apply if, upon inspection, it is found that the product was: misused or abused; used for a
purpose for which it was not designed; mishandled, placed in an improper environment; repaired by
unauthorized personnel; or improperly installed or adjusted.
The sole and exclusive remedy in the event of any breach of the foregoing warranty shall be for the original
purchaser to return the product to A&D, freight and insurance prepaid, for repair, replacement or credit, at
A&D’s option. Any product repaired or replaced under the foregoing warranty shall be shipped back to
customer freight and insurance prepaid.
EXCEPT AS PROVIDED ABOVE, A&D MAKES NO WARRANTY CONCERNING THE
PRODUCTS, EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED