Filter
Top Products
HW-G Instruction Manual Page 55
HW-G OZIM v1a
16.4 Preparation (Setting Parameters)
Step 1 Turn off the display.
Press the ON/OFF switch while the ZERO switch is
pressed and held. The function table is displayed.
Step 2 Select a parameter of the “baud rate ( f4 )” using
the ENTER and ^ switches.
Step 3 Select “command mode ( f5 1 )” of the “output”
using the ENTER and ^ switches.
Step 4 Select “format 1 ( f15 0 )” of the “format” using
the ENTER and ^ switches.
Step 5 Press the ENTER switch to store the new
parameters.
Return to the normal weighing mode using the
ENTER switch.
Step 6 Receiving a command, the scale responds.