Filter
Top Products
25
Key mode
Set the function “prt 1, 2 or 3”.
When the PRINT key is pressed while the weighing data is stable (the STABLE
indicator is on), the balance transmits the data. When the data is transmitted, the
display will blink one time.
Auto-print mode A
Set the function “prt 2”.
The balance transmits the weighing data when the display is stable (the STABLE
indicator is on) and the data is greater than +4d.
The next output can be obtained after the display returns below +4d.
Auto-print mode B
Set the function “prt 3”.
The balance transmits the weighing data when the display is stable (the STABLE
indicator is on) and the data is greater than +4d or less than -4d.
The next output can be obtained after the display returns between -4d and +4d.
Command mode
In the command mode, the balance is controlled by commands that come from the
personal computer and so on.
Command list
Command to request the current weighing data.
Command Q C
R
L
F
Reply S T , +001234. 5
g C
R
L
F
Command to zero or tare the balance (same as the RE-ZERO key).
Command Z C
R
L
F
Reply Z C
R
L
F
Command to change the weighing units (same as the MODE key).
Command U C
R
L
F
Reply U C
R
L
F