Filter
Top Products
Regulatory compliance
EMC compliance USA and Canada
FCC Radio Frequency Rules and Regulations
This equipment has been tested and found to comply with the limits for a Class A device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can emit radiated radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of
this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
NO MODIFICATIONS. Modifications to this device shall not be made without the written consent of 3M Company. Unauthorized
modifications may void the authority granted under Federal Communications Commission Rules permitting the operation of this
device.
FCC intentional radiator certification
FCC ID: QHKLSP3CLEAR
This equipment contains an intentional radiator approved by the FCC under the FCC ID number shown above. This device complies
with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Industry Canada radio frequency rules and regulations
This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numerique de la classe A respecte toutes les exigences do Reglement sur le materiel brouilleur du Canada.
CANADA: 7562A-LSP3CLEAR
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation of the device.
EMC compliance Europe
This equipment meets the requirements of the RTTE and EMC directives.
Copyright © 2009 3M. All rights reserved.
3