120
Picture and Sound Controls
Audio Delay
1 Press the SETUP button.
2 Select Sound > Digital Audio Output > Audio Delay and press the
OK button.
3 Press the
p
/
q
(arrow) buttons to select Auto or Manual.
Auto: This mode automatically adjusts the audio timing to meet
the video timing.
The time lag might be large between the image and sound
dependingontheconnectedequipment(amplieretc.).In
that case, select Manual.
Manual: You can manually adjust the audio signal timing to meet
the video signal timing.
4 Press the EXIT button.
Delay Adjustment
1 Press the SETUP button.
2 Select Sound > Digital Audio Output > Delay Adjustment and
press the OK button.
3 Press the
t
/
u
(arrow) buttons to adjust the audio signal timing (0 –
250ms) to meet the video signal timing.
4 Press the EXIT button.
NOTE
❖
This feature is grayed out when Audio Delay is in Auto.
❖
A time lag will occur when the video signal or audio signal is changed.
Adjust the timing accordingly.
❖
When adjusting the timing, turn down the volume of the AV equipment
used as far as possible.
Depending on the equipment, noise etc. may occur when the signal is
changed.
❖
Depending on the connected equipment (amplifier, etc.), adjustment
may not be possible.
❖
When the optical audio output setting (Auto
t
PCM) is changed, it
may be necessary to adjust the timing again.
❖
Do not use other than for audio output from the AV amplifier, etc.
(Malfunction may occur)
Adjusting the audio
