Waterpik Technologies WP-70 Electric Toothbrush User Manual


 
Prepare the Reservoir:
4
Adjust Pressure and Pause Control:
Replace
Fill
Insert
2
Select and Insert Tip:
6
Technique Tips for Best Results:
7
REGISTER YOUR
PRODUCT
ONLINE NOW!
PAUSE
Prime Unit (First Time Use Only):
3
High
Low
No
Gap
Always place tip in mouth
before turning unit on.
Receive up to
$
44
in savings.
www.waterpik.com/register
ON
OFF
PAUSE
5
Using your Waterpik
®
Water Flosser:
1
Model WP-60/65/70
Remove the reservoir
from base and fill with
lukewarm water.
Prior to Very First Use of Unit, Prime Unit:
Set pressure control slide switch on handle
to high, point the handle and tip into sink.
Turn unit ON until water flows from the handle,
turn unit OFF.
Press tip firmly into
handle. When tip is
properly inserted there
should be no gap between
control knob and tip. To
remove tip, simultaneously
hold control knob down
and lift tip up.
You can temporarily stop
water flow by pressing
the pause button on the
handle.
For first time
users, adjust
pressure control
to lowest position.
Gradually increase
pressure as you
prefer.
Aim the tip just above the gum line
at a 90 degree angle.
Starting with the back teeth, follow the
gumline and pause briefly between teeth.
Continue until all areas around and
between teeth have been cleaned.
Lean over sink and close lips
enough to prevent splashing,
while still allowing water to flow
from mouth into the sink.
Turn unit ON.
Always PAUSE or
turn unit OFF before
removing tip from
mouth. When finished
empty any excess
water from reservoir.
20012884-F AA
Water Pik, Inc.
1.800.525.2774 • www.waterpik.com
1730 East Prospect Road, Fort Collins, CO 80553-0001 USA
©2009 Water Pik, Inc.
Replace the
reservoir onto the base,
PRESSING DOWN FIRMLY
to ensure full seating.
continued
on back
QUICK START GUIDE
FRONT
radius: .125”
4.3125”
4”
BACK
radius: .125”
4.3125”
4”