Filter
Top Products
REMOVING BATTERY INSULATOR TAB
INTRODUCTION
SNAPSHOT PEDOMETER
USER GUIDE
/INSTRUCTION MANUAL
Congratulations on your purchase of a Sportline SnapShot Pedometer. The Snap-
Shot Pedometer features a highly advanced pedometer technology that accurately
measures your body movements when worn from multiple locations on the body
and in multiple orientations.
Please keep in mind your pedometer is a sensitive technical instrument. With
proper care and maintenance, it will last for many years. However, improper care
and handling can cause the various sensors to be damaged and to stop function-
ing.
HOW TO USE THIS MANUAL
Please read all sections of this manual carefully and become fully familiar with
the operation of the pedometer before using it in the field. Proper setup and op-
eration will greatly enhance the pedometer’s usefulness and your enjoyment. The
steps for the programming or operation are adjacent to the screen illustration.
Key points and important information are shown in highlighted blocks.
CUSTOMER SUPPORT
If you have questions, comments or need assistance with your Sportline Snapshot
Pedometer, you may contact Customer Support by calling 1-866-694-4575.
NOTE: In order to activate your pedometer after purchase, you must remove the
battery insulator tab inside the battery compartment.
1. Slide the battery compartment cover toward the bottom edge of the unit.
2. Remove the tab and be sure that the battery is in the correct polarity position
(positive (+) side of the battery is visible).
3. Replace the battery compartment cover and fasten by sliding back into place
(NOTE: cover will “click” into place and automatically seal).
4. Remove the label that appears on the pedometer display.
1 2 3
SNAPSHOT PEDOMETER
www.sportline.com
www.sportline.com
Sportline® is a trademark of SPORTLINE, a division
of EB Sport Group, Yonkers, NY 10701
Distributed in the UK by
EB Brands (UK), Worcester, WR4 9FA
All Rights Reserved. ©2011
SPXXXXXXXROD
PROGRAMMING THE PEDOMETER
4. Adjust Height by PRESSING the + or - keys. PRESS the SET key to accept value.
The unit will automatically calculate your Stride Length.
5. PRESS the SET key to accept this value or you can adjust your Stride Length
(see “Determining Stride Length” in far right panel) by PRESSING the + or -
keys.
6. PRESS the SET key. The unit is now programmed and ready for use!
4 5 6
PROGRAMMING THE PEDOMETER
In order to ensure exercise data is as accurate as possible, you must complete the
following steps to enter your personal profile:
1. Enter the Programming Sequence by PRESSING & HOLDING the SET key on the
back of the unit for approximately 3 seconds.
2. Select unit of measure (metric or imperial) by PRESSING the + or - keys on the
back of the unit. PRESS the SET key again.
3. Adjust Weight (in pounds or kilgrams) by PRESSING the + (to increase) or - (to
decrease) keys. PRESS the SET key to accept value and advance to set Height.
1
2 3
To adjust value:
PRESS + OR -
To accept and advance:
PRESS SET
OPERATING/RESETTING THE PEDOMETER
OPERATING THE PEDOMETER
The SnapShot Pedometer automatically begins capturing data once movement
occurs. There are no Start or Stop buttons to push.
TO CLEAR ALL CURRENT PEDOMETER DATA:
1. Press & Hold the RESET key on the front of the unit.
2. Continue holding as the display reads “RESET”.
3. When pedometer data reads zeros (O), release the RESET key. The unit is now
ready for a new workout.
NOTE: Your personal profile settings will be saved.
3
21