Sony D-E350 Portable CD Player User Manual


 
Portable
CD Player
Sony Corporation ©2001
Operating Instructions
About area code
The area code of the player you purchased is shown on upper left of the bar
code label on the package.
For accessories supplied with your player, check the area code of your model
and refer to “Supplied accessories” toward the end of this manual.
3-237-761-21 (1)
D-E350
D-E351
Playing a CD right
away!
If you want to play a CD right now, choose to use your CD player on
house current. You can also use it on dry batteries (see “Power Sources”
on the reverse side).
Connect
1
1 Press OPEN to open the lid.
OPEN
Place a CD
2 Adjust the volume.
2 Fit the CD to the pivot.
3 Close the lid.
2
Label side up
Not these ways
Press
> N
> N for 2
seconds or more
x
. once
. repeatedly
*
2
> N once*
2
> N
repeatedly
*
2
Hold down
> N
Hold down .
*
1
AMS = Automatic Music Sensor
*
2
After you have played the last track, you can
return to the beginning of the first track by
pressing > N. Similarly, if you are at the
first track, you can locate the last track by
pressing ..
To remove the CD
Remove the CD while pressing the pivot.
About the display
• When you press > N, the total number of
tracks in the CD and the total playing time
appear.
• During play, the track number and the
elapsed playing time of the current track
appear.
If the volume does not increase
If “AVLS” flashes in the display, hold down
SOUND until “AVLS” disappears from the
display. For details, see “To protect your
hearing (AVLS).”
About CD-Rs/CD-RWs
This CD player can play CD-Rs/CD-RWs
recorded in the CD-DA format*, but playback
capability may vary depending on the quality
of the disc and the condition of the recording
device.
* CD-DA is the abbreviation for Compact Disc
Digital Audio. It is a recording standard used
for the Audio CDs.
When closing the lid of the CD player
with the power supply attached
While the “disc” flashes in the display, the CD
starts rotating and will stop after the CD
player reads the disc information. This helps to
shorten the waiting time before playback
starts.
Notes on handling CDs
• To keep the CD clean, handle it by its edge.
Do not touch the surface.
• Do not stick paper or tape onto the CD.
• Do not expose the CD to direct sunlight or
heat sources such as hot air ducts. Do not
leave the CD in a car parked under direct
sunlight.
To
Play (from the
point you stopped)
Play (from the first
track)
Stop
Find the beginning
of the current track
(AMS*
1
)
Find the beginning
of previous tracks
(AMS)
Find the beginning
of the next track
(AMS)
Find the beginning
of succeeding
tracks (AMS)
Go forward
quickly
Go backwards
quickly
BOther Operations
Selecting play mode
You can enjoy the following five play modes:
“Normal play”, “Repeat play — all the
tracks”, “Single track play”, “Repeat play —
a single track” and “Repeat shuffle play”.
Press MENU during play.
Each time you press the button, the play
mode indication in the display changes as
follows:
No indication (Normal play)
The player plays all the tracks on the CD
once.
” (Repeat play — all the tracks)
The player plays all the tracks on the CD
repeatedly.
“1” (Single track play)
The player plays a single track you’ve
selected once.
1” (Repeat play — a single
track)
The player plays a single track you’ve
selected repeatedly.
SHUF” (Repeat shuffle play)
The player plays all the track on the CD
in random order repeatedly.
Play mode indication
m
m
m
m
MENU
m
Using other functions
To maximize the skip protection
performance (ESP MAX)
The typical ESP (Electronic Shock Protection)
function minimizes skipping by using a
buffer memory that stores music data and
plays it back in the event of a shock.
The ESP MAX system is an extremely
sophisticated technology. Due to the light
weight and improved anti-shock
characteristics of the optical block, this system
recovers from the skipping much quicker
than conventional technology such as ESP or
ESP
2
.*
* Although ESP MAX provides excellent
protection, skipping may occasionally occur.
Set ESP to “ON.”
The ESP indication appears.
To release the ESP MAX function, set ESP to
“OFF.”
Notes
Playing may stop when the CD player gets a
strong shock even with the ESP MAX function
on.
You may hear a noise or sound may skip:
— when listening to a dirty or scratched CD,
— when listening to an audio test CD,
— when the player receives continuous shock or
— when using poor-quality CD-Rs/CD-RWs or
if there is a problem with the recording
device or application software.
To enjoy more powerful bass sound
(Digital MEGA BASS)
You can emphasize the bass-boosted sound.
Press SOUND to select “BASS ” or
“BASS .”
“BASS ” enhances the bass sound more
than “BASS .”
Note
If the sound is distorted when using the
SOUND function, turn down the volume.
To turn off the operation beep
sound
You can turn off the beep sound that is heard
from your headphones/earphones when you
operate your CD player.
1 Remove the power source (AC power
adaptor or dry batteries) from the CD
player.
2 Connect the power source while pressing
x.
To turn on the beep sound
Remove the power source and then connect the
power source without pressing x.
m
m
m
ESP
To lock the buttons
You can lock your CD player against any
accidental operations.
Slide HOLD in the direction of the arrow.
When you press any button, “Hold” appears
in the display and you cannot operate the CD
player.
To unlock, slide HOLD in the opposite
direction of the arrow.
To protect your hearing (AVLS)
The AVLS (Automatic Volume Limiter
System) function keeps down the maximum
volume to protect your ears.
Hold down SOUND until “AVLS” appears in
the display.
If you turn up the volume to “ ”, you
cannot turn up the volume any more.
If you want to turn up the volume to more
than “ ”, hold down SOUND until “AVLS”
disappears from the display.
Note
If you use the sound function and the AVLS
function at the same time, sound may be
distorted. If this happens, turn down the
volume.
Connecting to other
stereo equipment
You can listen to the CD through other stereo
equipment or record a CD on a cassette tape.
Refer to the instruction manual of the other
equipment for details. Before making
connections, turn off each piece of equipment.
Notes
Before you play the CD, turn down the volume
of the connected equipment so as not to
damage the connected speakers.
If you turn up the volume to more than “
”,
the sound may be distorted.
LINE IN or
REC IN
Continue to the reverse side c
Stereo system,
cassette recorder,
radio cassette
recorder, etc.
To stop play, press x.
WARNING
To prevent fire or shock
hazard, do not expose
the unit to rain or
moisture.
Do not install the appliance in a confined
space, such as a bookcase or built-in cabinet.
To prevent fire, do not cover the ventilation
of the apparatus with newspapers, table-
cloths, curtains, etc. And don’t place lighted
candles on the apparatus.
To prevent fire or shock hazard, do not place
objects filled with liquids, such as vases, on
the apparatus.
Certain countries may regulate disposal of the
battery used to power this product. Please
consult with your local authority.
CAUTION
INVISIBLE LASER RADIATION WHEN
OPEN
DO NOT STARE INTO BEAM OR VIEW
DIRECTLY WITH OPTICAL
INSTRUMENTS
DC IN 4.5 V
i
When using
earphones
to an AC
outlet
1 Press > N.
SOUND
The selected sound mode is displayed.
BASS
BASS
No indication
(Normal play)
SOUND
Left (white)
Right (red)
Connecting cord
i
Play
3
“WALKMAN” is a trademark of
Sony Corporation.
AC power adaptor
Earphones
or
Headphones