Filter
Top Products
1
Fig. A
*Home Cafe is a trademark of the Proctor and Gamble Company. Black & Decker
is a trademark of the Black and Decker Corporation. Mr. Coffee is a trademark of
Sunbeam Products, Inc. National Presto is not afliated with these companies.
©2005 by NPI, Inc.
Fig. B
Flat
side up
Fig. C
instructions
Before using the Presto
®
MyPod
™
rellable coffee holder with your Home Cafe* pod coffee maker, be sure the coffee maker is in
good working condition.
Before First Use
Before rst use, wash the coffee scoop, rellable coffee
holder, and compacting cover in warm, soapy water.
Rinse thoroughly.
Brewing Coffee
1. Place a Presto
®
MyPod
™
coffee lter in the rellable
coffee holder.
2. Using the coffee scoop (Fig. A), pour 1 to 1½ scoops
of ground coffee on the lter in the rellable coffee
holder. Use 1 scoop for normal strength coffee and
1½ scoops for stronger coffee. Do not use more than
1½ scoops of coffee. Using a damp paper towel, brush
off any coffee grounds on the rim of the holder and
around the air vent before placing the holder in the
coffee maker.
Always look
through the air vent on the rellable coffee holder before each use to make certain it is clear
(Fig. A). If the air vent on the coffee holder is clogged, clean it with a soft brush or a ne wire.
For best results, use coffee ground for drip coffee makers. This is the same grind used in the
commercial pods.
3. Position the compacting cover over the coffee grounds so the at side is facing up (Fig. B) and
push it down rmly and completely to compact the coffee grounds. Depress retractable lifting
pin before use.
4. Remove the pod holder that came with your Home Cafe* pod coffee maker. Replace it with the
Presto
®
MyPod
™
rellable coffee holder (Fig. C) and follow the manufacturer’s instructions for
brewing coffee.
It is normal for the brewed coffee to contain a small amount of sediment. To minimize the sedi-
ment, clean off any coffee grounds on the rim of the holder before each use.
Removing and Cleaning Holder
1. Your Home Cafe* coffee maker operates under high pressure. After coffee is done brewing,
before opening unit, wait approximately one minute to allow pressure to reduce and excess water to drain through unit. It is
normal for a small amount of dripping to occur once the brewing cycle is complete.
2. Slowly open lid on your coffee maker and using the handle, carefully remove the coffee holder from the coffee maker.
Let
mypod
™
refillable coffee holder
(model 09401)
Replaces the Black & Decker* model HCC100 and
Mr. Coffee* model SSP10 Home Cafe* pod holder.