Filter
Top Products
MODEL J DIALTEMP™
INSTRUCTION
SHEET
M0102/0902
®
OMEGA
0
250
200
150
100
50
INTRODUCTION
The Model J Dialtemp
TM
is a non electronic thermometer that features a 360
degree swivel neck with a 90 degree tilt range of it’s large easy-to-read 5
inch dial face. The heliarc stainless steel welded construction provides a
moisture-proof bond, while preventing the possibility of rust and corrosion.
The temperature sensing device consists of sensitive bi-metal coils. They are
wound to pre-determined standards and are individually trimmed and
tested for full-scale accuracy, contributing minimum pointer vibration and
maximum heat transfer. One external reset screw enables fast and simple
recalibration. This superior DialTemp instrumentation design combines
high precision with durability and dependability, making the Model J
Thermometer ideal for a wide variety of applications.
UNPACKING INSTRUCTIONS
Remove the packing list and verify that all equipment has been received. If
there are any questions about the shipment, please call the OMEGA
Customer Service Department at 1-800-622-2378 or (203) 359-1660.
Upon receipt of shipment, inspect the container and equipment for signs of
damage. Take particular note of any evidence of rough handling in transit.
Immediately report any damage to the shipping agent.
The carrier will not honor any claims unless all shipping
material is saved for their examination. After examining and
removing contents, save packing material in event reshipment
is necessary.
HEAD ADJUSTMENT INSTRUCTIONS
Adjust the angle of the head before installing the Model J Thermometer.
Refer to Figure 1 to locate the adjustment screws.
Install the thermometer so that the maximum ambient head
temperature remains below 300°F (149°C) at all times.
1. Adjust the rotational position of the head by loosening the two bracket
bolts and rotating the bracket until the head is in the desired position.
NOTE
NOTE