T-35K25-SA
User’s Manual
Carefully insert the T-35K25-SA HDD cage into the bay
and push it inward until the T-35K25-SA HDD cage’s screw
hole is aligned with hole of the bay.
T-35K25-SA
3.Secure the T-35K25-SA
HDD cage is packed with
screws,use 2 screws on each
side to securely hold the device.
1. Do not eject the HDD while it is busy
2. Carefully take the HDD out from T-35K25-SA HDD cage.
The HDD can reach temperatures over 50 . It will not
burn the fingers but should be handled with care.
T-35K25-SA HDD cage
T-35K25-SA
SATA data cable
SATA+4PLED-MOLEX cable
key
Manual
Screw
T-35K25-SA
2
Lock
Easy latch door
1. Triangular lock, unlock with the key (counter-clockwise rotated 90 degrees),
open the panel;
1. Use the key “Counter-clockwise 90°” to open the door.
2. Take the HDD out from HDD cage, and firmly close the front
door .use the key “Clockwise 90°”to lock the door .
The contents of user’s manual are protected under copyright
law. Any organization or individual can not make copy and save
it in the information bank or the retrieval system by any method
or form without the authorization of iStarUSA.
T-35K25-SA is not responsible for any loss in the process of using
the HDD cage.
1 x 3.5" to 1 x 2.5" HDD Hotswap Trayless Drive Cage
Fits 2.5” SATA hard disk
III
233.3g/ 0.514lb
/ 5.51” x 4.00” x 0.98”
/ 32º~131ºF
101.6
6
cage
cage
T-35K25-SA Manual
1. Be sure to connect the 4P LED wire, or the LED indicator
will not be lighted up.
2. Before connecting the SATA data cable & SATA+4PLED
cable with the PC or with T-35K25-SA HDD cage, please
check there is no object on or beside the terminals that
may effect the mechanical assembly or become a
possible source of an electrical short.
1. Insert the SATA 15P connector into the T-35K25-SA’s 15P
connector, connect the big power 4P connector to the PC’s
4P power plug, and the small 4P LED wire connector to the
4P LED port at the back of T-35K25-SA.
2. Insert one end of the SATA data cable to T-35K25-SA,another
end(7P) to either the mother board or the SATA RAID card.
