Filter
Top Products
INSTALLING THE ANTI-THEFT
DEVICE (FIGURE 1)
1. Remove the upper four (4) phillips screws and
washers that secure the back upholstery to the
back canes.
NOTE: Phillips screws and washers will be reused.
2. Position the anti-theft device brackets with the
back upholstery screw holes.
3. Install the phillips screws through the washers,
anti-theft device brackets, back upholstery and
into the back canes.
4. T ighten the four (4) phillip s screws securely.
NOTE: Check all parts for shipping damage before
using. In case of damage, do NOT use. Contact the
Dealer/Carrier for further instructions.
SAFETY SUMMARY
The following recommendations are made for the
installation of the anti-theft device:
WARNING
DO NOT assemble or use this equipment with-
out first reading and understanding this instruc-
tion sheet. If you are unable to understand the
warnings, cautions or instructions, contact a
healthcare professional, dealer or technical
personnel before attempting to install this
equipment - otherwise, injury or damage may
occur.
NEVER maneuver an occupied wheelchair by
using
ANY part of the anti-theft device. Seri-
ous injury or damage can occur. ALWAYS use
the handles of the wheelchair when maneu-
vering an occupied wheelchair.
DESCRIPTION QTY
Anti-Theft Bar 1
Instruction Sheet 1
This kit contains the following:
Anti-Theft
Device
Back Cane
FIGURE 1 - INSTALLING THE ANTI-THEFT DE-
VICE
Phillips Screws
and Washers
Back Upholstery
Anti-Theft
Device Bracket
ANTI-THEFT DEVICE
Assembly, Installation and Operating Instructions
Model No. 1514
Invacare Corporation www.invacare.com
USA Canada
One Invacare Way 5970 Chedworth Way Invacare is a registered trademark of Invacare Corporation.
Elyria, Ohio USA Mississauga, Ontario ©
1999 Invacare Corporation
44036-2125 L5R 3T9, Canada
800-333-6900 905-890-8838 Form No. 84-63 Part No. 1003365 Rev D (1) 1/00