Homecare Enterprise Suitcase Ramp Mobility Aid User Manual


 
6441 REV 02-25-08
CE Technical Files kept at: CREE, Z.I. du Recou, F-69520, Grigny France
© 2005-2008 Homecare Products, Inc. All rights reserved.
INSTRUCTIONS FOR USE
Available in 2-, 3-, 4-, 5-, & 6-foot Lengths
Optional top lip extension is available. See below or contact your local EZ-ACCESS retailer for details.
1.
Maximum weight limit is 800 pounds.
2.
Read and follow all instructions before use.
3.
Do not use if ramp is damaged or unstable.
4.
Ramp is shipped fully assembled. To separate ramp into two halves for
easy stowage and transportation, remove bolts and install coil tension
safety pin as follows:
a. With ramp positioned as shown in
(
DIAGRAM
1), insert the coil
tension safety pin into each hinge assembly and join ramps
together before use. NOTE: Spring section of pin should be on
the underside (non-treaded side) of ramp.
b. WARNING: Ramp may be separated for use when
loading/unloading unoccupied mobility equipment.
c. WARNING: When used with occupied mobility equipment,
use ramp as one unit (ensure both halves are joined with pins or
bolts firmly installed before use).
5.
Place ramp on landing in the folded position, making sure that the top lip
(labeled TOP) is resting securely on the landing (
DIAGRAM
2).
6.
Unfold ramp and center on landing.
7.
For ease in carrying and stowage, ramp can be disconnected and
carried in two sections. (When pins are not in use, store in one side of
hinge or on the underside of ramp by inserting into the gap behind the
top I-beam.)
8.
WARNING: Ensure that the top lip is secure before using ramp. We
recommend attaching the ramp temporarily to the landing using the
provided clevis pins (drill 1/4” hole in landing) or semi-permanently
using screws through the pre-drilled holes at the top of each section. To
prevent ramp from becoming dislodged during use, ensure that the top
lip overlaps the resting surface as far as possible.
9.
WARNING: The surface holding the top lip needs to be
substantial; make sure that the surface and supporting structure is of
sound construction.
10.
WARNING: Use ramp only with a qualified helper and always use
lap belt.
11.
WARNING: The ramp shown in diagrams (below) is the 5-ft
length. To select the ramp length, an incline chart is provided on the
reverse side of this document. However, it is intended only as a
guideline. Refer to your equipment's (wheelchair or scooter) Owner
Guide for the proper degree of incline/decline and chair direction
before attempting ramp use. Never exceed its recommendations.
12.
SAFETY & MAINTENANCE: Regularly check ramp for damage, and
check and tighten any loose fasteners. Keep ramp surface clear of ice,
snow, dirt, leaves, and other debris. For snow/ice, remove
accumulation and sweep the surface clean. To remove dirt, leaves,
and other debris, sweeping the surface or using a garden hose will
usually suffice, but, if needed, use a damp cloth or soft brush with non-
alkaloid detergent and water. Rinse well and use extra caution if ramp
surface is wet.
13.
OPTIONAL FEATURE: Increase the usefulness of the SUITCASE
®
Advantage Series
®
Ramp with the Top Lip Extension (TLE). This
optional extension increases the standard 3” lip to become 9”, allowing
the ramp to clear the rear bumper of SUVs and vans by simply
attaching to the top lip of the ramp (
DIAGRAM
4). TLE is for use with
unoccupied mobility equipment only and, when used, reduces the
overall ramp weight capacity to 500 pounds. Contact your local
retailer or visit www.ezaccess.com for details.
DIAGRAM 1 DIAGRAM 2 DIAGRAM 3 DIAGRAM 4
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
1. EZ-ACCESS, a division of Homecare Products, Inc., herein referred to as Manufacturer, warrants that equipment is free from defects in material and
workmanship under normal use and service. This limited warranty is non-transferable and applies to original owner, effective for a period of 3-years from the
date of original retail purchase (original dated purchase receipt is required) and applies to metal structure only (excludes powder coated finish and applied
non-skid tread). No part of this warranty will apply to any equipment which has been subject to misuse, vandalism, negligence, alteration, accident, improper
installation, or which has been repaired outside Manufacturer’s place of business in any way as in the reasonable judgment of Manufacturer, to adversely affect
its performance and reliability, nor to normal deterioration due to wear, tear and exposure, corrosion, damage caused by rain, fire, earthquake or other natural
causes or acts of nature.
2. The attached registration card must be mailed within 10-days of purchase. Manufacturer’s obligation under this warranty is limited to repairing or replacing, at its option, equipment
which is returned to Manufacturer’s place of business with a return authorization number (SEE #4 FOR DETAILS) and which, upon examination, shall disclose to Manufacturer
reasonable satisfaction to have been thus defective. Manufacturer will make the repair or replacement of defective parts under this warranty without charge for parts or labor.
3. If Manufacturer finds that any equipment has not provided the warranted service life, Manufacturer will, as its sole obligation and the user’s sole remedy for breach of this
warranty, repair or replace the unit, at its option, for a charge prorated on the following basis. The user will be allowed a credit against the list price of equivalent equipment at the
time of return to Manufacturer, in proportion to the percentage of the warranted service life remaining at the time of return to Manufacturer. Purchaser will be responsible to pay
the balance of the list price of equivalent equipment; and Manufacturer reserves the right to require payment prior to delivery of the repaired/replacement equipment.
Manufacturer’s whole warranty responsibilities are summarized below (return shipping/delivery charges to be paid by the Purchaser). NOTE: In calculating available credit, the
remaining warranted service life is rounded up or down to the nearest whole year. YEARS 0-1: Unit repaired or replaced; YEARS 1-2: Repair or 50% $ credit (current list price
multiplied by credit percentage); YEARS 2-3: Repair or 25% $ credit (current list price multiplied by credit percentage).
4. If Purchaser discovers a defect, he/she must call Manufacturer at 253-249-1101 to request an RA# to return, at his/her own expense, the merchandise to Manufacturer. Prior to
returning product, digital images of merchandise (close-up of defect, plus photo of overall product) must be submitted (an email address will be provided at the time an RA# is
given). The duration of any implied warranty of merchantability or fitness for a particular purpose shall be limited in all respects to the duration of the limited warranty and the
warranty described above shall be in lieu of any other express warranty. Some states do not allow limitation on how long an implied warranty will last so the above limitation may
not apply to you. Manufacturer neither assumes nor authorizes any other person to assume for it any other liability in connection with Manufacturer.
5. The buyer’s sole and exclusive remedy against the Manufacturer shall be for the repair or replacement of defective merchandise as provided above. No other remedy, including
but not limited to, incidental or consequential damages for lost profits, lost sales, injury to property, or any other incidental or consequential loss shall be available to him/her.
Labor to remove, ship, and/or reinstall ramp is not covered my manufacturer's warranty. Because some states do not allow the exclusion or limitation of incidental or consequential
damages, the above limitation or exclusion may not apply to you. Before using, user shall determine the suitability of the product for its intended use and user assumes all risk and
liability whatsoever in connection therewith.
6. This warranty gives you specific legal rights. You may also have other rights, which vary from state-to-state.