Graham Field 6482R-2 Bathroom Aids User Manual


  Open as PDF
of 2
 
6486R-2-INS-LAB-RevA11 1
6482R-2/6482ER-2: DELUXE TOILET SEAT RISER WITH ARMRESTS
ASSEMBLY & OPERATION INSTRUCTIONS
PLEASE SAVE THESE INSTRUCTIONS FOR FUTURE USE
Info: The most current version of these instructions can be found online at www.grahamfield.com
Tools required: Phillips or blade screwdriver
WARNING:Important!Readandunderstandtheseinstructions
beforeinstallingorusingtheToiletSeatRiser.Ifyoudonotunder-
standanypartofthesewarnings,cautionsorinstructions,contact
ahealthcareprofessionalfordirectionintheuseofthisproduct.If
thetoiletseatriserisnotproperlyassembledandinstalled,person-
alinjuryanddamagetothetoiletseatrisercouldresult.
WARNING:Ifcomponentsaredamagedormissing,contactyour
dealerimmediately.DONOTusesubstituteparts.UseonlyLumex
replacementparts.Non-Lumexreplacementpartscouldcauseper-
sonalinjuryanddamagetothetoiletseatriser.
WARNING:Thisproducthasaweightlimitof300lb.
WARNING:GFHealthProducts,Inc.assumesnoresponsibilityfor
anydamageorinjurycausedbyimproperassembly,installationor
useofthisproduct.
INSTALLATION
1. Remove toilet seat riser, hardware, and armrests from carton and protec-
tive packaging.
2. Install the armrests with the following steps:
a. Identify the right and left armrests by the R (Right) and L (Left)
stamped into armrest ends.
b. Note that each toilet seat riser armrest socket is also stamped with an R
or L, as shown at right. Insert each armrest marked with R or L into the
socket with the corresponding letter.
c. Push each armrest into its sockets until it clicks into place.
d. Ensure locking buttons protrude fully from holes. Pull on armrests
slightly to test proper installation. If loose, repeat step c.
3. At the toilet, lift the cover plates at top rear toilet bowl rim, exposing the
bolts holding the seat and lid to the toilet bowl.
4. Use a Phillips or blade screwdriver, whichever is appropriate, to unscrew
toilet seat bolts by turning counterclockwise.
5. Remove the toilet seat and lid from the toilet bowl and set them aside.
6. Place the toilet seat riser over the toilet bowl rim so that the toilet seat
riser mounting holes align with the toilet
rim holes.
7. Place the toilet seat and lid on top of the toilet seat riser so that the seat/
lid holes align with the riser and rim holes.
8.
Install a washer on one of the long bolts included in the box and insert it
through the top of the toilet seat lid, toilet seat riser, and toilet bowl rim.
9. Place a washer and wing nut on the end of the long bolt that protrudes
through the bottom of the toilet bowl.
hardware
bolt
washers
wing
nut
right armrest shown installed
(shown upside down)
“R” on armrest socket
locking button
toilet seat riserarmrest
6482ER-2, one arm attached
(shown upside down)
mounting holes
6482R-2 assembled
6482ER-2 assembled