1
IMPORTANT:
Refer to www.extron.com for the complete
user guide, installation instructions, and
specifications before connecting the
product to the power source.
IMPORTANT:
Refer to www.extron.com for the complete
user guide, installation instructions, and
specifications before connecting the
product to the power source.
IN1604 Series • Setup Guide
The Extron IN1604 DTP and IN1604 HD Scaling Presentation Switchers are four input, HDCP-compliant video scalers that accept a wide variety
of audio and video formats. This guide allows an experienced user to set up and congure an IN1604 Series scaler. It covers how to perform basic
operations using the front panel controls and selected Simple Instruction Set (SIS™) commands.
NOTE: For full installation, configuration, menus, connector wiring, and operation details, see the IN1604 Series User Guide, at
www.extron.com.
Installation
Rear Panel Features
HDMI
HDMI HDMI3
4
21 CONFIGURABLE
100-240V ~ 0.5 A MAX
50-60 Hz
REMOTEAUDIOINPUT
OVER TP
OUTPUT
TALLY OUTCONTACT IN
HDBT
DTP
L
12
R
L
R
Tx Rx G
3214+V1234G
Tx RxTx
GRx
RS-232
OUT
IN
RS-232 IR
SIG
OUT
LINK
BC
F
G
MD
A
Power and Input Connections Output Connections Control Connections
A
AC power connector
B
Configurable analog 15-pin HD (VGA)
connector (input 1)
C
HDMI input connectors (inputs 2-4)
D
Unbalanced analog audio input connector
(input 1)
E
Balanced or unbalanced analog audio input
connector (input 2)
F
Balanced or unbalanced analog
audio output connector
G
TP output connector
(IN1604 DTP only)
H
TP output switch (IN1604 DTP only)
I
RS-232 and IR Over TP
connector (IN1604 DTP only)
J
HDMI output connector
(IN1604 HD only)
K
Contact closure connector
L
Tally connector
M
Remote RS-232 connector
Figure 1. Rear Panel Features (IN1604 DTP Shown Left and Unique IN1604 HD Features Shown Right)
Mounting and Cabling
Step 1 — Mount the device.
a. Turn off or disconnect all equipment power sources.
b. Mount the IN1604 Series scaler on top of a at surface using the provided rubber feet, under a table using an optional mounting kit for
under-the-desk mounting, or to a rack shelf using an optional rack shelf-mounting kit.
Step 2 — Connect inputs.
a. Connect an analog video source (RGB, YUV, S-video, or composite) to the 15-pin HD (VGA) connector (see gure 1,
B
)
b. Connect digital HDMI or DVI (with an appropriate adapter) sources to the HDMI connectors (
C
).
c. Connect an unbalanced analog audio source to the 3.5 mm, female TRS (tip-ring-sleeve) audio connector (
D
). See Audio Wiring on
page 3 for more details.
d. Connect a balanced or unbalanced audio source to the 5-pole captive screw connector (
E
). See Audio Wiring on page 3 for more
details.
HDMI HDMI3
HDMI4
21 CONFIGURABLE
100-240V ~ 0.5 A MAX
50-60 Hz
AUDIOOUTPUT
TALLY OUT
CONTACT IN
L
R
LR
Tx Rx G
3214+V
1234G
RS-232
HDMI
REMOTE
DI
L
IN1604 HD
