Filter
Top Products
IMPORTANT SAFETY
INSTRUCTIONS
When using electrical appliances, especially
when children are present, basic safety
precautions should always be followed, includ-
ing the following:
READ ALL INSTRUCTIONS
BEFORE USING.
KEEP AWAY FROM WATER.
DANGER - Any appliance is electrically
live even when the switch is off. To reduce the
risk of death by electric shock:
1. Always unplug appliance immediately
after using.
2. Do not use while bathing or in the shower.
3. Do not place or store appliance where it can
fall or be pulled into a tub or sink.
4. Do not place in, or drop into, water or other
liquids.
5. If an appliance falls into water, unplug it
immediately. Do not reach into the water.
WARNING - To reduce the risk of
burns, electrocution, fire, or injury to persons:
1. This appliance should never be left
unattended when plugged in.
2. Do not pull, twist, or wrap line cord around
appliance.
3. This appliance should not be used by, on
or near children or individuals with certain
disabilities.
4. Use this appliance only for its intended
use, as described in this manual. Do not use
attachments not recommended by the manu-
facturer.
5. Never operate this appliance if it has a
damaged cord or plug, if it is not working
properly or if it has been dropped or dam-
aged, or dropped into water. Return the
appliance to an authorized service center
for examination and repair.
6. Keep the cord away from heated surfaces.
7. Never use while sleeping.
8. Never drop or insert any object into any
opening.
9. Do not use outdoors or operate where
aerosol (spray) products are being used or
where oxygen is being administered.
10. Unit is hot when in use. Do not let
heated surfaces touch eyes or skin.
11. Do not place the heated unit directly on
any surface while it is hot or plugged in.
12. Never block the air openings of the appli-
ance or place on a soft surface such as a
bed or couch, where the air openings may
be blocked. Keep the air openings free of lint
and other debris.
13. Do not use an extension cord with this
appliance.
14. Do not touch hot surfaces of the appli-
ance. Use handles or knobs.
15. Do not attempt to touch the housing of
your appliance near the straightening plates,
as it is hot when in use.
SAVE THESE
INSTRUCTIONS
OPERATING
INSTRUCTIONS
This styling iron is intended for household
use. Use on Alternating Current (60 hertz)
only. This unit is designed to be operated at
120 volts AC.
This appliance has a polarized plug (one blade
is wider than the other). As a safety feature,
this plug will fit in a polarized outlet only one
way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact
a qualified electrician. Do not attempt to defeat
this safety feature.
TO STYLE HAIR
Hair should be clean and completely dried
before using the styling iron. Plug the iron
into an electrical outlet. Turn on unit. The
Power/Low setting will become illuminated.
To turn off, press Off button (light will go off).
Never leave your styling iron on and unat-
tended. However, should you fail to turn the
unit off, it will shut itself off automatically
within 60 minutes.
WARNING: The styling iron’s tourmaline
ceramic-coated plates will get very hot
within a few seconds.
GETTING STARTED
The iron’s unique three high-heat temperature
settings and Instant Heat technology provide
styling versatility for all hair types. If you have
fine hair, a low temperature will provide the best
results. If you have thick, wavy or hard-
to-style hair, keep the heat setting on high.
You can vary the iron’s temperature according
to your particular need!
STRAIGHTENING
Start with a hair section that is 1 in. wide
and no more than
1
⁄2 in. thick. Open the iron
and place a hair section between the two hot
plates, close to the scalp. Trap hair between
the plates by firmly squeezing the handles
together. While maintaining the tension,
slowly pull the unit down along the hair sec-
tion toward the ends of hair. For best results,
use a light styling product before blow-drying
hair. At the end of hair section, release the
pressure on the handle and allow the hair
section to slide out. Repeat process on addi-
tional sections of hair until you achieve the
hair style you desire. It may be necessary to
repeat process on certain areas, depending on
the texture of your hair.
CRIMPING
Push the converter switch to change plates to
crimp. Take a section of hair about 1 in. wide.
Starting at the scalp, close unit over hair and
hold for 5–10 seconds. Repeat, moving down
hair towards ends. You can easily go back and
forth, switching plates to achieve a variety of
crimp/textured styles.
USING INSTANT HEAT, THE HIGH
HEAT TEMPERATURE SETTINGS &
UNIFORM HEAT RECOVERY SYSTEM
This styling iron features a ceramic heater that
maintains temperature during use for precision
styling. It heats up to the temperature you’ve
selected for your hair type.
This Instant Heat technology has three
high-heat temperature settings. There is a
temperature range that’s gentle and safe
for every type of hair, from the finest to the
curliest and most resistant, to help you create
the look you want. And that’s not all. Conair’s
professional salon standards of engineering
provide you with a uniform and improved heat
recovery system that maintains the iron at a
constant temperature. There is a constant surge
of power to ensure that heat is continuously
and quickly delivered for optimal styling results,
unlike other irons which lose heat during use.
This provides consistent styling power so that
every strand of your hair is set with the same
level of heat and comes out the same way for
a perfect finish.
Temperature Setting Guide
LED TEMP. CONTROL HAIR TYPE
Low Delicate, thin,
easy-to-style hair
Medium Average to thick or treated hair
High/Max Hard-to-style hair
CRIMP OR STRAIGHTEN WITH 1 TOOL
10pa114858_s6_ib_mech.indd 110pa114858_s6_ib_mech.indd 1 7/16/10 11:05:30 AM7/16/10 11:05:30 AM