Conair LT3CS Electric Shaver User Manual


 
OPERATING
INSTRUCTIONS
BEFORE USE:
Prior to initial use, test trimmer on small area
of arm or leg. If any signs of allergic reaction
or sensitivity occur, discontinue use. Do not
use trimmer on ultra sensitive or irritated skin.
TO OPERATE TRIMMER
This trimmer comes with a two trimming
blades. The larger blade can be used to trim
body hair and eyebrows. The smaller blade is
ideal for detailing.
It also comes with an attachment comb that
helps you achieve an even cut when you do not
want to completely remove the hair. The attach-
ment comb has two sides, the longer tooth is
good for body hair while the shorter one is good
for eyebrow trimming. Aligning
the indicator with the L mark on
the comb leaves hair longer while
aligning with S mark leaves hair
shorter.
To use the attachment comb, be
sure the unit is in the “off”
position and slide it over the trimming blades.
Make sure that the teeth of the comb are facing
in the same direction as the trimming blade and
that the top of the comb is even with the top of
the trimmer. (See Fig. 1)
If you want to completely remove hair, use the
trimmer without the attachment comb.
To operate the trimmer, slide the “on” switch
towards the trimming blades. When you are fin-
ished trimming, slide the “on” switch away from
the blades.
To replace battery first remove the hold down
screw at bottom of outer housing. Remove
lower housing and remove/replace battery and
re-assemble to cover housing.
To store the Trimmer, slide the
attachment comb cover the trimming
blades. Be sure to align triangle sign
on the comb attachment with indicator
on the trimmer housing.(see Fig. 2)
Then slide the protective cap over the
attachment comb so that the triangle
sign on protective cap aligns with the
triangle sign on
the handle tube
(see Fig. 3)
TRIMMING TIPS
1. Place the trimmer at a slight right angle to
the skin, and trim in the direction of hair
growth.
2. Continue trimming in the direction of
growth. Be careful not to apply excess
pressure to the blade. This may damage the
blade, and can result in injury to the skin
during trimming.
3. Pull the skin firmly with one hand during
the trimming process to ensure the closest
possible shave.
REPLACING THE BATTERY:
1. Be sure appliance is off and remove the
protective cap. Hold the upper part of the
trimmer firmly and pull off battery cover.
(Handle tube)
2. Insert 1 “AAA” battery. Pay close attention,
SL
fig. 1
2
TRIMMER
Ladies
IN ONE
®
Instruction Guide
For your safety & continued
enjoyment of this product,
always read the instruction book
carefully before using.
Model LT3CS
ON
Fig.2
Fig.3
Long
Tooth
Short
Tooth
Protective Cap Handle Tube
INSTRUCCIONES
DE USO
PRUEBA PRELIMINAR
Antes de usar su aparato por primera vez,
haga una prueba en un área pequeño del
brazo o de la pierna. Si ocurra alguna
irritación o reacción alérgica, deje de usar el
aparato. No use el aparato en la piel muy sen-
sitiva o irritada.
USAR SU CORTADORA
Su cortadora incluye dos cuchillas. La cuchillas
grande se puede usar en los vellos del cuerpo y
las cejas. La cuchilla pequeña es perfecta para
los recortes de precisión.
Su cortadora también incluye un peine acceso-
rio que le permite acortar los pelos de forma
pareja sin rasurarlos. El peine accesorio tiene
dos lados. El lado con los
dientes más grandes acorta los
vellos del cuerpo y dejará el pelo
más largo, mientras el lado con
los dientes más pequeños acorta
las cejas y dejará el pelo más
corto.
Para instalar el peine accesorio, asegúrese que
su aparato esté apagado, luego deslice el peine
encima de las cuchillas, asegurándose que los
dientes del peine estén alineadas con las
cuchillas y que la parte superior del peine esté
alineada con la de la cortadora.
Si desea rasurar los pelos, use la cortadora sin
el peine accesorio.
Para encender el aparato, deslice el interruptor
hacia arriba. Para apagar el aparato, deslice el
interruptor hacia abajo.
Cuando quiera almacenar la cortado-
ra, deslice el peine accesorio encima
de las cuchillas, alineando la marca
triangular que se encuentra sobre el
peine con la marca que se encuentra
sobre el aparato (Fig. 2). Luego,
coloque la cubierta protectora enci-
ma de las cuchillas, alineando la
marca de la cubierta con la del
agarre (Fig. 3).
CONSEJOS PARA EL RECORTE
1. Coloque la cortadora ligeramente en ángu-
lo contra la piel y corte o rasure en la direc-
ción del crecimiento del pelo
2. Siga cortando en la dirección del crec-
imiento del pelo, sin ejercer mucha presión
sobre las cuchillas. Esto podría dañar las
cuchillas y lastimar la piel.
3. Estire la piel firmemente con su mano libre
mientras rasura. Esto le dará un rasurado de
cerca.
CÓMO CAMBIAR LA BATERÍA
1. Asegúrese que el aparato esté apagado y
saque la cubierta protectora. Mantenga la
parte superior de la cortadora firmemente y
jale el agarre.
2. Inserte una batería de tipo “AAA”. Para
evitar que el aparato se dañe, asegúrese que
la batería esté instalada correctamente
(polos +/-). Si no va a usar el aparato durante
SL
fig. 1
2
TRIMMER
Ladies
IN ONE
®
INSTRUCCIONES DE
USO
Para su seguridad y para seguir
disfrutando de este producto durante años,
siempre lea las instrucciones cuidadosa-
mente antes de usarlo.
Modelo LT3CS
ON
Fig.2
Fig.3
Dientes
Grandes
Dientes
Pequeños
Cubierta Protectora Agarre
03NP623 LT3CS IB 11/12/03 4:42 PM Page 1