IMPORTANT
SAFETY
INSTRUCTIONS
When using electrical appliances, especially
when children are present, basic safety pre-
cautions should always be followed, includ-
ing the following:
READ ALL INSTRUCTIONS
BEFORE USING
KEEP AWAY FROM WATER
DANGER – Any hair dryer is
electrically live even when the switch is off.
To reduce the risk of death or injury by
electric shock:
1. Always “unplug it” immediately after using.
2. Do not use while bathing.
3. Do not place or store appliance where it
can fall or be pulled into a tub or sink.
4. Do not place in, or drop into, water or other
liquid.
5. If an appliance falls into water, “unplug it”
immediately. Do not reach into the water.
WARNING – To reduce the risk
of burns, electrocution, fire, or injury to persons:
1. This appliance should never be left un-
attended when plugged in. Do not pull,
twist, or wrap line cord around dryer.
2. This appliance should not be used by, on,
or near children or individuals with certain
disabilities.
3. Use this appliance only for its intended use
as described in this manual. Do not use attach-
ments not recommended by the manufacturer.
Do not use an extension cord to operate dryer.
4. Never operate this appliance if it has a
damaged cord or plug, if it is not working
properly, if it has been dropped, damaged,
or dropped into water. Return the appliance
to a Conair Service Center for examination
and repair.
5. Keep the cord away from heated surfaces.
Do not wrap the cord around the appliance.
6. Never block the air openings of the appli-
ance or place it on a soft surface, such as a
bed or couch, where the air openings may be
blocked. Keep the air openings free of lint,
hair, and the like.
7. Never use while sleeping.
8. Never drop or insert any object into any
opening or hose.
9. Do not use outdoors or operate where
aerosol (spray) products are being used or
where oxygen is being administered.
10. Do not use an extension cord with this
appliance.
11. Do not direct hot air toward eyes or other
heat-sensitive areas.
12. Attachments may be hot during use.
Allow them to cool before handling.
13. Do not place appliance on any surface
while it is operating.
14. While using the appliance, keep your hair
away from the air inlets.
15. Do not use with voltage converter.
For a dual voltage hair dryer:
16. Be sure dual voltage selector is in correct
voltage position before operating. Before
plugging in, read the information about dual
voltage contained in the instruction section of
this manual.
17. This appliance was set at the factory to
operate at 125 volts. Refer to Additional
Information section of this manual for con-
version to 250 volt operation.
SAVE THESE
INSTRUCTIONS
OPERATING
INSTRUCTIONS
This appliance is intended for household use
only. Use on Alternating Current (50/60 hertz)
only. Standard Dryers are designed to operate
at 110 to 125 volts A.C. For special dual voltage
dryers, see Additional Information.
This appliance has a polarized plug (one blade
is wider than the other). As a safety feature,
this plug will fit in a polarized outlet only one
way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact
a qualified electrician. Do not attempt to defeat
this safety feature.
IMPORTANT
1875 WATT OPERATING GUIDE
Use of this dryer on the same circuit or fuse with
other electrical products or appliances may trip a
15 amp circuit breaker or blow a 15 amp fuse.
NEVER replace the fuse with one rated higher
than the capacity of the circuit. Doing so could
result in an electrical fire.
WHAT TO DO IF HAIR DRYER ACCIDENTALLY
FALLS IN WATER
PLEASE NOTE: When the electrical elements
of the hair dryer come in contact with water,
the Protection Plus
®
Plug is designed to shut
down immediately.
1. Be sure to unplug the hair dryer.
2. Remove from water. Once the appliance is
removed from water, it should be returned to a
Conair service center.
REMEMBER: Do not use the hair dryer after it
has fallen in the water until it has been serviced.
CHECK ALCI SAFETY FEATURE EVERY TIME
YOU USE APPLIANCE.
This appliance is equipped with an Appliance
Leakage Circuit Interrupter (ALCI), a safety
feature that renders it inoperable under some
abnormal conditions, such as immersion in
water. To make sure the ALCI is functioning
properly, perform the following test. The pur-
pose of this test is to allow you to make sure
the water sensing system (ALCI) is working.
1. Plug in the appliance and press test button
on plug (See appropriate diagram below).
2. The appliance will stop working. There will be
an audible click and reset button will pop out.
3. To reset ALCI with a reset button, unit should
be unplugged. Then push reset button in, and
reinsert plug into outlet.
4. If ALCI is not functioning properly, return
appliance to nearest service center.
5. It is important that if immersion occurs,
this unit be brought to a service center. Do not
try to reset.
6. Be sure to repeat test every time you use
the unit to confirm ALCI is operational.
Should the appliance go off and the reset but-
ton pop up during use, this could indicate a
malfunction in the unit. Remove plug from
outlet and allow the appliance to cool.
Reinsert plug into outlet.
The appliance should then function normally.
If not, return to an authorized Conair Service
Center for evaluation and repair.
SUPER STYLING GUIDE
Your best looks begin with a good haircut that’s
well maintained. Always treat hair right with
Conair
®
and Jheri Redding
®
superior quality
shampoos, conditioners, and finishing products.
DRYING BASICS
1. Shampoo and condition hair with Conair
®
or
Jheri Redding
®
products of your choice. Rinse
thoroughly. Towel blot hair to remove excess
moisture. Section hair. Using the dryer along
with your styling brush, direct hot air through a
section of hair at a time. Move dryer steadily
across each section so that the hot air passes
through hair. Direct air flow at hair, not scalp.
2. Keep dryer’s air intake vents unobstructed
and free from hair while drying.
3. To avoid over drying, do not concentrate heat
on any one section for any length of time. Keep
dryer moving as you style.
4. For quick touch ups between shampoos,
dampen hair with a mist of water before
styling with the dryer.
5. When using your dryer to create curls and
waves, dry hair almost completely on a warmer
temperature setting, then finish styling with the
special turbo cool shot feature to close hair shaft
and lock in style.
BODY & VOLUME
To create extra volume, turn head upside down
while drying. Position the air flow toward the
roots for maximum lift. When hair is dry, toss
head back and brush hair into place.
STRAIGHTENING
Work with hair in sections when creating a
super straight look. Using a large round brush
(approximately 2" in diameter), hold hair taut
in each section and bend ends slightly under
as you dry.
MAKING WAVES
Tousled, natural-looking waves are easily creat-
ed by grasping hair at the roots and scrunching
between fingertips while drying. No matter what
your style, the Conair
®
and Jheri Redding
®
col-
lection of expert hair care products will see you
through from start to finish.
The Conair
®
Quiet Tone
®
Dryer with 1875
watts of power lets you dry and style in
comfort while allowing you to hear everything
else going on around you.
FEATURES
1. Cool Shot Feature Locks in Style
After styling with warm air, press the cool
shot button. The fan accelerates and speeds
cool air to the hair, closing the hair shaft and
locking in style.
2. Power
1875 watts of drying power.
3. 2 Speeds/2 Heats
for styling versatility.
4. Removable air filter
for easy cleaning.
5. Dual voltage
for worldwide travel.
GET TO KNOW YOUR DRYER
Removable Filter
2 Heat/Speeds
Cool Shot
Dual Voltage
As soon as there’s a new professional styling
tool, Conair brings it to you!
CAUTION: Always use diffuser on low
heat/speed. NEVER USE HIGH HEAT/SPEED
SETTING when the Speed Drying Diffuser is
fitted to dryer, as this may lead to damage to
hair dryer and diffuser attachment due to
abnormal heat build-up.
1875 Watts
Quiet Fan Design
Reset
Test
Reset
Test
04PC2058 060QR IB 6/11/04 10:00 AM Page 1