Filter
Top Products
MP070-7PS-2 & MP070-7PS-1 7" Modular Windshield Suction Pedestal
Consumer Hotline:
(USA) (800) 841-0884
(INT'L) (626) 254-9005
Mon-Fri. 9am-5pm, PST
www.arkon.com
Arcadia, CA 91006 USA
Made in Taiwan
© Copyright 2007 Arkon Resources, Inc.
The Mobile Mounting Specialists
TM
MP070-7PS-2
MP070-7PS-1 with a single T-tab is also available with the same set of
instructions listed below.
Step 1.
Step 2.
Locate a safe flat surface on
the dash or console to mount
the pedestal. Clean the dash
with the alcohol pad
provided. Dry the surface
before applying the adhesive
disc (C).
Push the pedestal suction cup
(A) firmly to the disc (C). Flip
the lever (B) down to secure
the suction cup.
Dash Installation (Optional,
when disc is included)
(C)
(A)
(B)
(A)
(D)
(E)
(F)
(F)
(G)
(B)
Step 1.
Windshield Installation
Push the pedestal suction cup (A) firmly to the windshield.
Flip the lever (B) down to secure the suction cup.
Step 1.
.
Pedestal Adjustment
Adjust the vertical angle of the pedestal shaft by 180° and
the swivel rotation by 360° by loosening the adjustment
knob (D). Adjust the lateral angle of the dual T-head (F) by
180° and the rotation by 360° by loosening the adjustment
knob (E).
Step 1.
Attach the device cradle to the pedestal by inserting the dual T-
tabs (F) of the pedestal into the T-slots of the cradle (G). (cradles
are sold separately and vary depending on the device you are using)
Device Cradle Installation
Pedestal
Shaft
Safety Precautions
Do not install Arkon products over an air bag cover or within the air
bag deployment zone. Arkon Resources, Inc. assumes no
responsibility of liability for injury or death as a result of car crashes
and/or air bag deployment.
Arkon Resources, Inc. is not responsible for any damages caused to
your car, your device, or yourself due to the installation or use of the
pedestal mount.